Qualcast QG-PT 3043 Petrol Lawn Trimmer Instructions

30cc
Petrol Grass Trimmer QG-PT 3043
Quick Start Guide
Your Safety is most important please read these
safety rules before you use this machine
General Safety Rules
Read user manual before using the machine
Wear safety goggles to guard your eyes from possible injury
Wear gloves to protect your hands
Wear safety shoes to protect your feet
Wear hearing protection
Note - This quick start guide is intended for experienced users who have already assembled the tool,
please refer to the manual for further details
Quick Start Guide
Items Included
1
Do you have questions?
We can help
Call Customer Service
Mon-Thur 08:45 am - 5:00 pm
Friday 08:45 am - 3:15 pm
2
5
3
6
7
1 Lower Shaft
2 Engine & Upper Shaft
3 Bottle of 2 stroke oil
4 Plug Socket Spanner
8
4
5 Mixing Bottle
6 Carry Strap
7 Handle
8 Guard
0151 649 1500
Spare Parts also available
1
Unpack the Grass Trimmer
a) Open carton carefully and remove all items
b) Ensure you have all items (see above) before you discard the packaging
2
Assembling the Grass Trimmer
Connect bottom shaft (1) to Upper shaft & engine (2) making sure the square drive shaft on lower shaft (1) is inserted into square drive on
upper shaft (2) correctly and ensure the spring loaded locking clip is aligned with the hole provided and in place and the securing
knob is tightened. If the drive is not correctly inserted then the spool will not turn.
Bottom Shaft (1)
Securing knob
Upper Shaft (2)
Securing knob
3
For your Safety
You must fit the guard provided for your safety. Remove the the screw, washer and locknut fro the guard (see Fig 1).
Place the guard over the lower shaft (see Fig 2), replace the bolt and tighten (see Fig 3).
Also fit the centre handle. Undo the wing nut and remove the bolt (see Fig 4) push, the handle over the upper shaft (see Fig 5), replace
the bolt and secure with the wing nut (see Fig 6). Fit the carry strap to the unit with the clip to the hook on the upper shaft (see Fig 7)
Fig 1
4
Fig 2
Fig 3
Fig 6
Fuel / Lubrication
a) Mix the fuel in the mixer bottle provided
b) Shake the container gently to ensure that it is properly mixed.
N.B Failure to use the correct oil/fuel mixture will cause the
engine to seize
5
Fig 5
Fig 4
Fig 7
Use regular grade unleaded
petrol and quality 2 stroke oil
Fuel Mixture is
40:1 (40 parts Fuel to 1
part 2 stroke oil)
Starting the Grass Trimmer
1. Set the machine down on a hard, level surface.
2. Set the choke to „ “
3. Press the fuel pump (primer) 10 times.
4. Set the ON/OFF switch to “I”.
5. Hold the appliance firmly in one hand by the handle,
above the throttle lock.
6. Pull the starter cord briskly 8 times.
7. If the motor has been started, let the motor warm up
(automatic choke reset function in place for the throttle lock).
If the engine does not start up immediately, repeat steps 1-7 above.
To stop the machine immediately, set the ON/OFF switch to “STOP" (0).
Engine switch
“ON/OFF" (1/0)
Throttle lever release
Starter cord
Throttle lever
Fuel Cap / tank
Primer bubble
Rotary choke