Ultrastar 15K73 Quick Installation Guide v1.0

Ultrastar 15K73 Quick Installation Guide v1.0
Quick installation guide
Hitachi Ultrastar 15K73
Ultra320 SCSI Hard disk drive
Model Numbers: 68 Pin Interface:
80 Pin Interface:
SPECIFICATIONS
Formatted Capacity*(Gbytes)
Bytes per Sector*
#Cylinders/#Heads/#Disks
Maximum LBA*(Hex)
Seektime:Average(Read. Typical)
Spindle Speed rpm
Interface Type
Transfer rate (MB/s)
Operating Temperature (C/F)
Power: 12Vpeak(Typ)/5V peak (Typ) (A)
Start Time(s)
HUS157373EL3600 HUS157336EL3600
HUS157373EL3800 HUS157336EL3800
73.9 GB
512
40664/10/5
89B88FF
3.9/4.2
15037
Ultra 320
320.0 max
5-55°C
2.20/1.54
25
36.9 GB
512
40664/5/3
44DC47F
3.9/4.2
15037
Ultra 320
320.0 max
5-55°C
2.20/1.54
25
Handling Precautions
1. Do not press on the drive. Hold the drive by the sides only, do not apply any force to the drive during
handling or installation.
2. Always handle the drive with care to prevent damage from shock, vibration or electrostatic
discharge(ESD). Do not touch the Printed Circuit Board (PCB).
3. Electrostatic Discharge. Static electricity can damage the drive. Before handling the drive, touch an
unpainted metal surface for a few seconds to drain any static electricity from your body.
4. Keep the original packaging and static-protective bag in case the drive has to be returned.
Mounting Orientation
1. Installation horizontal or vertical ( 6 directions)
2. Provide adequate air flow to cool drive
3. Use 4 mounting screws (6x32 UNC). Maximum screw penetration 3.8mm (0.15 in) into drive
Cable Specifications:
1. Use interface cables that meet the ANSI SCSI guideline.
2. Cable length:
Interface cable (NW, Single-ended mode)
Cable Type
SCSI Interface
DC power supply
Flat Ribbon or
Twisted Pair
AWG#20
Maximum cable length
Fast-5
Fast-10
6m
3m
(16 units max.) (16 units max.)
3m
Ultra(Fast20)
3m(4 units max.)
1.5m (8 units max.)
7/28/2003
v1.0
1
Interface cable (NW, LVD mode)
Cable Type
SCSI Interface
DC power supply
Maximum cable length
Ultra2(Fast)-40,Ultra160(Fast-80),Ultra 320(Fast-160)
12m (16 units max.)
Flat Ribbon or
Twisted Pair
AWG#20
3m
Connector Layout:
Wide LVD 68pin-16bits (NW)
SCA-2 LVD 80 pin-16bits (NC)
Option Jumper Connector C3
NW
Pin
Function
Removed
1-2
ID3
*
Installed
Function
NC
Removed
ID3
*
Installed
7/28/2003
v1.0
2
3-4
5-6
7-8
9-10
ID2
ID1
ID0
Disable Auto Start
11-12
Force SE bus
mode
*
*
*
At power on per
C3 pins 13-14
Single-ended or
LVD mode*
13-14
Enable delay start
At power on*
15-16
17-18
19-20
21-22
23-24
Write Protect
Reserved
Reserved
LED(with 0 Ohm)
Term Power
Write Enable*
In 10 sec x ID
intervals on power
on
Write Protected
Termpwr not to
SCSI Bus*
Termpwr to SCSI
bus
•
Only by SCSI
Command
Only by SCSI
Command
ID2
ID1
ID0
Disable Auto Start
*
*
*
Refer note3 below
Force SE bus
mode
Single-ended or
LVD mode*
Enable delay start
At power on*
Write Protect
Reserved
Reserved
LED(with 0 Ohm)
Term Power
Write Enable*
In 10 sec x ID
intervals on power
on
Write Protected
Termpwr not to
SCSI Bus*
Termpwr to SCSI
bus
Only by SCSI
Command
Only by SCSI
Command
Indicates Default Settings. Do not Change the reserved jumper pins! Changing will void warranty! Spare
jumpers C3: 2-4, 6-8, 12-14-16,18-20 for NW model, C3: 18-20 for NC model.. These spare jumpers can be used
for another setting.
7/28/2003
v1.0
3
© Copyright Hitachi Global Storage Technologies
Hitachi Global Storage Technologies
5600 Cottle Road
San Jose, CA 95193
Produced in the United States
7/03
All rights reserved Travelstar™ is a trademark of
Hitachi Global Storage Technologies.
Microsoft, Windows XP, and Windows are trademarks of
Microsoft Corporation in the United States, other
countries, or both.
Other product names are trademarks or registered trademarks of their respective companies.
References in this publication to Hitachi Global Storage
Technologies products, programs or services do not imply
that Hitachi Global Storage Technologies intends to make
these available in all countries in which Hitachi Global
Storage Technologies operates.
Product information is provided for information purposes
only and does not constitute a warranty.
Information is true as of the date of publication and is
subject to change. Actual results may vary.
This publication is for general guidance only. Photographs may show design models.
28 July 2003
7/28/2003
v1.0
4
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement