Whip Mix 3Shape Scanner, Computer User manual

Whip Mix – 3Shape System Unboxing Steps




Pre-Install Checklist
Wired Ethernet connection to a router or switch with Broadband Internet Service.
Strong, sturdy surface with no vibration for the scanner to operate on.
Area that is free of large temperature fluctuations and not in direct sunlight or directly under air vents.
It is recommended to plug your PC into an Uninterruptable Power Supply to protect this device from power
surges and unexpected power outages. You can purchase these at any internet or local based retail stores.
o Examples: www.amazon.com , www.newegg.com , www.tigerdirect.com , Best Buy , Radio Shack
o DO NOT plug your 3Shape Scanner into a battery backup port as it may not provide enough power to the
scanner to properly function. Use the “Surge Only” ports.
Required Items
1.
2.
3.
4.
3Shape 3d Scanner (Included)
3Shape Scanner Calibration Kit (Included)
Computer Tower (Included)
1 x 10A, 125V Power Cable (Included)
5.
6.
7.
8.
USB Keyboard (Included)
USB Mouse (Included)
Computer Monitor (Purchased Separately)
1 x DVI or HDMI Video Cable (Purchased Separately)
PC Unboxing and Setup









(Diagram on 2nd page)
Remove the PC Tower from its box and place the equipment on a solid, stable surface or enclosure.
Position the USB Mouse and Keyboard in place and plug the USB connection into any of the vacant ports on the
very bottom of the PC Tower (Refer to the diagram on page 2nd page).
Attach an Ethernet cord from the back of the PC tower to you network switch/router.
Run a DVI or HDMI Video Cable from the available port on the back of the Computer Tower to the back of the
monitor. For DVI connections, make sure you secure the connection using the screws on the cable tips.
Plug in Power Cord to the Power Supply of the PC Tower.
3Shape Scanner Unpacking and Setup
Remove 3Shape 3D Scanner and the included Calibration Kit from the Wooden Crate.
Remove the foam brace from inside your 3Shape Scanner
Wire the included USB Data Connection Cable from the back of the 3Shape 3D Scanner to an open USB port on the
BACK of the PC Tower.
Plug the blue USB License Dongle (Included in the Calibration Kit) into a vacant lower USB port on the BACK of
the PC Tower. (Use caution when maneuvering around the PC tower once the dongle is inserted to avoid damage to the USB Dongle)
Calibration Steps
1. Turn the PC on and log in to Windows 7 with the password: scan
2. Switch on the Power button on the back of your 3Shape Scanner
3. If prompted, Install any newly detected hardware using recommended or automatic settings; otherwise the system
will automatically complete this operation and notify you when the hardware has been installed via notification
message in the bottom right-hand corner.
4. Run the “Scan Server / ScanSuite” application using the Desktop shortcut
 (You can also find this under Start > All Programs > 3Shape > Scan Server.)
5. The scanner should initialize. When it is done you will notice the scan Server icon in the Task Tray will have a
green square that is solid; if it is blinking, the scanner is still working and you must wait until it goes solid. Click
on the “Calibrate Scanner” button and follow the step by step instructions on the screen.
6. Repeat step 6 and re-calibrate the scanner a 2nd time to ensure accuracy – You only need to calibrate twice
whenever the scanner is transported. Normally, you can expect to calibrate your scanner once every 2 weeks or as
needed.
PC DIAGRAM:
">