1-800-562-7760

(314) 447-2100 www.coastalbusiness.com

Digi-Trans

No Weed Laser Transfer Paper

Light Colors

Before you begin

Digi-Trans has no background polymer window found on standard transfer papers. It works in most color laser printers and copiers. Keep paper away from high humidity and away from moisture. Recommended for use on light colored, 100% cotton polyester, or poly/cotton blend fabrics.

Printing Instructions

1. Preparing Image

-Paper should be fed one sheet at a time.

-Check your printer’s manual for recommended

paper settings. If you are having trouble

printing, you may need to select a heavier

paper mode like transparency or label mode.

-Print design on the paper with the correct

orientation. (MIRROR/REVERSE the image.)

This can be done within the printer’s property

panel. For additional information, see your

printer’s instruction manual.

-Print the image on the blank side of the

transfer paper. (Not the side with the text.)

-Paper should be fed into the printer short

dimensions first. (grain long)

Transferring Instructions

1. Preparing for Transfer:

Heat Press Application (REQUIRED)

-Prepare heat press at 330 degrees F.

-Place heat transfer paper with image

facing down in desired position on fabric.

-Using above recommended temperature,

apply medium to heavy pressure for

25-30 seconds.

2. Peel While Warm

-Wait 15-20 seconds and

slowly peel backing

paper off garment.

2. Repress With Silicone

-For increased washability and durability,

cover with silicone sheet and press for

additional 25 seconds.

Before Washing

Leave finished item for at least 24 hours before wash.

Wash inside out in cold water. Dry at normal heat settings. Do not use bleach, fabric softener, or harsh detergents. Turn inside out and tumble dry on a low to moderate heat temperature settings.

Using a Textile Metallic Foil with transfer

Most metallic foils can be used to highlight the transfer. Place the t-shirt with the transfer back into the press, cover the area that you want highlighted with the foil, and cover the entire transfer with a silicone sheet. Press at same settings.

IMPORTANT: We thoroughly test each of our products on various substrates using different transfer equipment. However, it is impossible for us to duplicate all variables using all substrates and transfer equipment. Therefore, it is essential that you test the paper prior to production using your equipment, methods, and substrate material. Heat presses vary in accuracy. Conduct tests to determine the best time and temperature to use with your equipment.

Please keep in mind that the Seller’s and Manufacturer’s maximum obligation shall be to replace any paper that has proven to be defective. Neither the

Seller nor the Manufacturer shall be liable for injury, direct or consequential, arising out of the use of, or inability to use the paper.