HPS.01.223.910
HONDA Varadero XL 1000 ab 2003
Hebegriff
Montagehinweise
Alle vom Motorrad gelösten Schrauben sind gemäß
Herstellerangaben wieder zu montieren, oder mit von
SW-MOTECH gelieferten Schrauben zu ersetzen. Falls nicht anderweitig definiert, diese Schrauben nach
Tabelle anziehen.
M6
M8
M10
9,6 Nm
23 Nm
46 Nm
Lifting Grip
Mounting Instructions
SW-MOTECH products should be installed by a qualified, experienced motorcycle technician. If you are unsure of your ability to properly install a product, please have the product installed by your local motorcycle dealer. SW-MOTECH takes no responsibility for damages caused by improper installation.
All screws, bolts and nuts, including all replacement hardware provided by SW-MOTECH, should be tightened to the torque specified in the OEM maintenance manual for your motorcycle. If no torque specifications are provided in the OEM maintenance manual, the following torques may be used: Gegebenenfalls Schrauben mit flüssiger
Schraubensicherung einkleben.
Prüfen Sie nach 50 km alle Verbindungen auf festen
Sitz.
M6
M8
M10
9,6 Nm
23 Nm
46 Nm
All screws, bolts and nuts should be checked after driving the first 50 km to ensure that all are tightened to the proper torque.
Medium strength liquid thread-locker (i.e., "Locktite") should be used to secure all screws, bolts and nuts.
SW-MOTECH GmbH & Co. KG
Bahnhofstrasse 44d
35282 Rauschenberg
-Germany-
Tel.: ++ 49 (0) 6425 8168 00
Fax: ++ 49 (0) 6425 8168 10 www.sw-motech.com
!
Achtung: nur für Modelle ohne
Fahrwerksverstellung.
Attention: only for motorcycles without an adjustable undercarriage.
1
Hebegriff
Lifting Grip
HPS.01.223.003
Anzahl/ Pcs.
1
2 Bügelschraube
Bow Screw
3
Mutter mit Bund
Lock Nut
BUS.06.028.042
Anzahl/ Pcs.
2
1 2 3 2
M6 DIN 6927
Anzahl/ Pcs.
4
3