HN 10 Series HN-510 HN1010
RFM products are now
Murata Products
Built on the heritage of the original FHSS family of modems and combining the advanced features of the
WIT2410 OEM module, there is a HN 10 Series modem that suits every need, from the relative comfort of an
office to the harsh conditions on the factory floor to the unpredictable weather of an outdoor location.
Based on 2.4GHz frequency hopping spread spectrum technology, all HN 10 Series modems provide
extraordinary range while providing immunity to jamming and multipath fading. All backed by extensive
experience in wireless technology. All HN 10 Series standalone modems feature a high data rate (460Kbps
over the air) and long range (over 5 miles using HN 10 external gain antennas). Both point-to-point and pointto-multi-point network configurations are supported.
HN510
HN-1010
HN-1510
HN 10 Series
HN-510
HN1010
HN-1510
HN2010
HN-3010
2.4 GHz StandAlone Modems
HN-2010
HN-3010
HN-510
HN-1010
HN-1510
HN-2010
HN-3010
The HN-510 has the same
components as its
ruggedized siblings in a
desktop-style enclosure that
provides compact size and
weight with a built-in
rechargeable battery pack.
Simply connect to a PC’s
RS-232 port using the 510’s
DB-9 connector and it’s
ready to go. Front panel
LEDs give complete power
and communications status
at a glance.
The HN-1010 is enclosed in
a NEMA 4X and I.P. 66 rated
housing and can operate
outdoors from
-30OC to +70OC. The unit
features a 9 pin I/O
connector for data, power,
and flow control. Transmit
and receive data are RS485 compatible differential
signals while the flow control
lines are single-ended
RS-232. This interface can
drive up to 250 feet of cable
and can be converted to
plain RS-232 using the
HopNet 3500 data/power
adapter.
The HN-1510 features a
rugged enclosure for indoor
industrial applications. The
HN-1510 has a standard
DB-9 connector for I/O and
all data and flow control
lines are RS-232 signals.
Power is supplied via a
separate 2-pin connector.
The HN-1510 also provides
a 4 LED readout for power
and status indications.
The HN-2010 is a dual
wireless modem repeater
that can be used to create
complex extended range
networks, either point-topoint or point-to-multi-point.
Half and full duplex I/O rates
from 1200bps to 230.4Kbps
are supported. The HN2010 is housed in a NEMA
4X and I.P. 66 rated
enclosure for outdoor
operation between -30OC
and +70OC. A standard
DB-9 data connector is
provided to allow
configuration of the
repeater. Because two
wireless modems are used
back-toback, the full
throughput of the data
channel is available. Single
modem, store and forward
repeaters reduce the
throughput of the entire
system and add latency.
The HN-3010 is a compact
stand-alone modem with an
integrated patch antenna.
Housed in a NEMA 4X and
I.P. 66 enclosure, the HN3010 is a cost-effective,
one-piece, pole-mounted
transceiver. The HN-3010
has an operating
temperature range of -30OC
to +70OC. A single 9 pin
connector provides data,
flow control, and power.
Data signals are differential
RS-485 compatible, while
the flow control lines are RS232.
©2010-2015 by Murata Electronics N.A., Inc.
HN-10 Series (R) 01/15/15
1 of 2
www.murata.com
Specifications
HN-510
HN1010
HN-1510
Frequency Band
HN-2010
HN-3010
2401 – 2483 MHz
Licensing
Unlicensed under FCC Part 15, ETSI 300.328
Number of Channels
75
Hopping Patterns
User configurable, 64 patterns (networks) available
I/O Data Rate
Up to 230.4 Kbps asynchronous
RF Channel Rate
460 Kbps
Line-of-Sight Range
>5 Miles with 9 dB omni antenna
RF Bandwidth
750 KHz
Modulation Type
GFSK
Output Impedance
50 ohms
Network Protocol
ARQ: CSMA/CA or TDMA
Transmit Power
+18dBm
+18 dBm
+18 dBm
+18 dBm
Receive Sensitivity
-93 dBm
-93 dBm
-93 dBm
-93 dBm
EIRP: +24 dBm
-99 dBm
Power Requirements
5Vdc
750mA max.
9Vdc – 24Vdc
160mA typ. @ 9 Vdc
750mA surge
9Vdc – 24Vdc
160mA typ. @ 9Vdc
750mA surge
13Vdc – 24Vdc
500mA min. @ 13Vdc
9Vdc – 24Vdc
160mA typ. @ 9Vdc
750mA surge
Serial Data Interface
Async. RS-232
Async. RS-485/RS-232
Async. RS-232
Async. RS-232
Async. RS-485/RS-232
HN-1010
HN-1510
HN-2010
HN-3010
Mechanical Specifications
HN-510
Antenna
Case Materials
External
External
External
2 External
Integrated patch
Plastic
Aluminum
Aluminum
Aluminum
UV stabilized polyamide
NEMA 4X, IP 66
Dimensions(mm)
NEMA 4X, IP 66
NEMA 4X, IP 66
130 x 95 x 25
213 x 142 x 53
200 x 145 x 51
213 x 145 x 76
175 x 160 x 61
275g
820g
725g
1590g
570g
Reverse SMA
TNC
TNC
TNC
n/a
DB-9
Conxall model#
3282-9SG-528
DB-9
DB-9
Conxall model#
3282-9SG-528
2-Pin DIN
Conxall model#
16282-2SG-311
In data connector
Conxall model#
16282-2SG-311
In data connector
HN-1010
HN-1510
HN-2010
HN-3010
Weight
Antenna Connector
Data Connector
Power Connector
Environmental Specifications
HN-510
Temperature Range
0OC to + 50OC
-30OC to + 70OC
Humidity
95% at + 40OC, non-condensing
©2010-2015 by Murata Electronics N.A., Inc.
HN-10 Series (R) 01/15/15
2 of 2
www.murata.com
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement