HHC-908 Brochure
PROJECT
QUANTITY
Heated holding cabinet
ITEM NO
MODEL
HHC-908 half-size
Institutional
Heated Holding Cabinet model HHC-908
with 5-inch (127 mm) casters and extra
width, depth and racking options for
institutional kitchens.
Standard Features
• Durable, high-quality stainless steel
construction, interior and exterior.
• Precise thermostatic controls and
dial thermometer.
• Easy to see on/off and cycle
temperature lights.
• New standard adjustable racking
system increases capacity and pan
variety.
• Large stainless steel water pan.
• Manual slide vent humidity control.
• Dual heavy-duty blower motors.
• Ventilated side racks.
• Partial pan removal for convenient
loading and unloading.
• Fully insulated doors, sidewalls and
control module.
… APPROVED
General Information
Henny Penny heated holding
cabinets are designed to hold a wide
range of cooked foods at safe
temperatures for long periods of time
prior to serving.
The 900 series holding cabinets
were originally developed to hold
large quantities of pressure-fried
chicken for long periods of time
without sacrificing freshness or
presentation. Dual fans, ventilated
side racks allow hot, moist air to
circulated evenly throughout the
cabinet and keep practically any
menu item hot and tasty until
serving. And that translates into
higher food quality and less waste
throughout the day.
Henny Penny holding cabinets
also improve your equipment and
labor utilization. With longer holding
periods, operators can cook in
• Full perimeter door gasket.
• Self-closing, lift-off doors stay open
past 90 degrees.
• Magnetic door latch and heavy-duty
plated hinges.
• Sturdy aluminum base and
permanent center braces for added
strength.
• Built-in utility handle included on
solid back unit.
• Standard 5 in. (127 mm) casters,
two locking.
… APPROVED AS NOTED
AUTHORIZED SIGNATURE
quantity before peak periods and
stock heated display cases directly
from the holding cabinet.
The HHC-908 is a half-size mobile
heated holding cabinet with extra
width and depth to handle different
pan orientations and sizes common in
institutional kitchens. The half-size
units provide excellent holding
capabilities for lower volume and cost.
Several racking configurations are
available.
Additional standard features such
as stainless steel construction, fully
insulated doors and cabinet walls,
and self-closing doors help protect
food quality, reduce waste and
provide for more efficient workflow.
Please specify desired configuration
Shelf runners (see back)
… Standard
… Original
… Euro rack
Door hinge
…Right OR …Left
Style
…Pass-through OR …solid back
… RESUBMIT
DATE
Henny Penny Corporation
PO Box 60 Eaton OH 45320 USA
+1 937 456.8400
+1 937 456.8434 Fax
800 417.8417
800 417.8434 Fax
www.hennypenny.com
© 2006 Henny Penny Corporation, Eaton, OH 45320 USA Revised 08/25/07
PROJECT
ITEM NO
Heated holding cabinet
MODEL
HHC-908 half-size
Institutional
Power cord from back or top
37 in.
(940 mm)
PLAN
FRONT
29 ¼ in. (743 mm)
Dimensions
Height: 37 in. (940 mm)
Width:
29 ¼ in. (743 mm)
Depth:
35 ¾ in. (908 mm)
Required clearances: N/A
Crated dimensions
Length: 39 ½ in. (1000 mm)
Depth:
39 ½ in. (1000 mm)
Height: 34 ¾ in. (880 mm)
Volume: 31.4 cu. ft. (0.88 m³)
35 ¾ in. (908 mm)
Laboratory certifications
Pan capacity
Adjustable racking for standard sheet pans
and full-size steam table pans. Please check
desired runner style.
Standard Henny Penny
5 pairs on 3 ¾ in. (86 mm)
…
centers
…
Original Henny Penny
4 pairs on 4 1/8 in. (105 mm)
centers
Water connections: N/A
…
Euro Rack
3 pairs on 5 ½ in. (140 mm)
centers
Heating
Thermostat controlled, 160-210°F (71-99°C)
Electrical
Crated weight: 249 lbs. (113 kg)
Humidity: 1 gallon (3.8 liter) water pan
Bidding Specifications
• Provide Henny Penny Model HHC-908
institutional half-size Heated Holding
Cabinet. Units are designed to hold hot
foods in quality condition at safe
temperatures for long periods of time.
• Units are designed with extra width, depth
and racking options for varying pan
configurations in institutional kitchens.
• Unit shall have electro-mechanical
Volts
120
230
230
240
Phase
1
1
1
1
Cycle/Hz
50-60
50
50
50-60
Watts
2086
1900
3000
3086
Amps
17.0
8.3
13.0
12.8
Wire
2+G
1NG
1NG
2+G
thermostat and temperature controls.
• Provide choice of right or left-hand door,
solid back or pass-through design.
• Provide choice of racking configurations for
3, 4 or 5 pans.
• Unit is 300 grade stainless steel
construction throughout.
• Unit features full perimeter door gasket and
fully insulated sidewalls and control module.
Power cord supplied. Plug included for
120V USA and Canada, only.
G
Plug type: NEMA 5-20P
W
• Two heavy-duty blower motors and ventilated
side racks.
• Unit includes built-in utility handle on solid
back models.
• Unit comes with (4) 5 in. (127 mm) casters,
two are locking.
Continuing product improvement may subject specifications to change without notice.
www.hennypenny.com
© 2006 Henny Penny Corporation, Eaton, OH 45320 USA Revised 08/25/07
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement