Two-Component Foam Kits Use Guidelines Products Jump To:

Two-Component Foam Kits Use Guidelines Products Jump To:
2 Component Polyurethane Foam Insulation Guidelines
Company
Jump To:
New Products
Troubleshooting
Use Guidelines
MSDS
Foam Yields
Refillable Foam Systems
Products
Technical Info & FAQ's >
Technical Info & FAQs
Industry Links
Reps Only
Use Guidelines > Two Component Use
Two-Component Foam Kits Use Guidelines
ALWAYS review and follow the directions provided in your
foam kit. The below instructions are a general overview,
meant to accompany the reference photos. ENSURE you
follow all safety precautions including wearing protective
eyewear and gloves.
Click on pictures to enlarge
Prepare the Area
1. Make sure area to receive foam is clean and dry.
2. Ensure the area has adequate ventilation. If flowthrough ventilation isn’t possible, wear respiratory
gear and ensure you can exit the area quickly if
fumes become overwhelming.
3. Ensure appropriate ambient temperature. Check
application temperature in the instructions or click
here for a quick reference guide.
Figure 1
Set-up the Foam System
1. Rock the box or tanks to agitate the product
thoroughly.
Figure 2
2. Ensure foam is brought to a temperature between
70-90°F before dispensing. Failure to ensure proper
temperature may affect product performance.
3. Tear open the top of box along perforated lines
(Figure 1).
4. Remove instructions and accessories bag (Figure 2).
5. Make sure gun is “OFF” by pushing trigger lock into
gun body.
6. Attach hoses. Connect the red hose to the red
cylinder (unit A), connect the white hose to the white
tank (unit B), inserting hoses into carton holes.
Tighten hoses with wrench provided.
7. Close cartons, unlock gun and spray into waste
container to ensure chemicals distribute evenly and
equally from both hoses.
8. Lubricate o-ring (petroleum jelly is fine).
9. Select spray nozzle (yellow for fan pattern/flat areas,
transparent for high-velocity linear spray/cracks and
voids). Align slots on nozzle with notch on gun barrel
and push/twist nozzle clockwise to lock in place
(Figure 3).
http://www.touch-n-seal.com/twocompuse.htm[8/24/2011 4:27:39 PM]
Figure 3
2 Component Polyurethane Foam Insulation Guidelines
10. Spray again into waste container to ensure product is
mixing properly. The foam should be off-white in
color (not brown or white – which indicates one unit
is not working properly)
( Figure 4). Call our customer service group at 800325-6180 if you believe your foam kit isn't spraying
properly.
Figure 4
11. Foam is now ready to apply.
Site Map - Copyright © 2006
http://www.touch-n-seal.com/twocompuse.htm[8/24/2011 4:27:39 PM]
Convenience Products, Fenton, MO USA - 800 -325 -6180
Terms of Use
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising