Quick Install Guide sc1dn-S and trk-101

Add to my manuals
2 Pages

advertisement

Quick Install Guide sc1dn-S and trk-101 | Manualzz

Quick Install Guide

sc1dn-S and trk-101

Network (Ethernet)

Camera/Video Source (not required for ioimage cameras)

1. Click the DNA icon and run the DNA utility

(DNA.exe). DNA discovers all devices on the network.

2. If there are authenticated devices, on the DNA toolbar, click the Login icon and enter login credentials for the devices.

3. If there are devices located on a separate VLAN, add them manually by clicking on the DNA toolbar.

4. Enter the unit’s default IP address (A) in your browser.

5. When the Login window (B) opens, enter the trk-101 or sc1dn-S default user name and password.

Properly rated power supply

1. From the Live View window, access the

Camera Setup by clicking Setup > Camera

> Streaming.

2. In the Video Standard box, select the required video format (PAL/NTSC). By default, NTSC is the default Video

Standard selection.

Once the standard has been selected, confirm that other predefined settings will be deleted.

3. When completed, click Apply to save settings.

1. From the Live View window, select Setup > Analytics > Depth >

Solo Setup. The following instructions are displayed on the screen.

2. On the Solo Setup control keypad, click the Start Recording icon and select a folder where to store the clip.

3. Press Stop Recording.

4. Proceed to the tab for Step 1: Ground & Height to place ground and height markers and guidelines in the clip.

5. Click Browse to load and view the clip. Navigate the clip and add human markers.

6. Exit Clip mode and return to Live mode by pressing the round Play button on the control panel located to the left of the monitor.

Continue setting depth by proceeding to the tabs for Steps 2-4.

Follow the on-screen instructions. Expand the Help section included with each step for detailed information.

Verify that the settings provide an accurate representation of the sizes and distances in the scene.

When finished, click Apply to save settings.

From the Setup tab, select Analytic > Rules.

A rule for detecting humans or vehicles entering the scene (blue masked area) is defined by default.

You can activate rules, modify settings, delete, or add a new rule.

To create a new rule:

1. Click New.

2. Select the rule type.

3. Draw on the video scene where you want the detection to take place.

4. Define the attributes for detection.

5. When finished, click Apply to save the settings.

1. From the Live View window, select Setup.

2. Select Arm. The camera is ready to use.

Notice: Failure in part or in whole of the installer, owner, or user in any way to follow the prescribed procedures or to heed warnings and cautions provided in the installation and user manual shall absolve DVTEL and its agents from any resulting liability.

Warning: THIS EXAMPLE IS FOR DEMONSTRATION PURPOSES ONLY.

For deployment in live applications, such as security, safety and loss prevention programs, installers, owners and users should read and follow the installation and user manual prescribed procedures provided. Installation should follow safety, standards, electrical codes and security best practices as well as the laws that apply where the units are being installed .

sc1dnS-trk101_QIG_Jan16_14

DVTEL, Inc. 65 Cha llenge r Road Ridgefield Pa rk, NJ 076 60

Tel: 201-368-970 0 Fax: 201-386-261 5 Order Fax: 201.712.034 3 [email protected] ww w.dvtel.com

advertisement

Was this manual useful for you? Yes No
Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Related manuals

Download PDF

advertisement