DK 9530
9 5 3 0 MAX IM U M
G A T E O p erator
• User adjustable variable speed control
• Slow-start / slow-stop operation
• High tensile strength roller chain provides
a direct mechanical linkage to the gate,
will not slip and is unaffected by weather
or other contaminates such as dirt, oil,
grease, ice, etc.
• Integral internal direct driven limit switch
system cannot be tampered
with externally
• 5-year limited warranty
10 ga steel housing option
variable speed control
direct drive
limit switches
large gates
up to 10,000 pounds
Access Control Solutions
O p erator
9530 3 HP
54” W x 59” H x 26” D
3 HP
(137.16cm W x 149.86cm H x 66.04cm D)
Class of Max Gate Max Gate MOTOR Input operation Length *
Weight *
160 Ft 10,000 Lbs. 3 HP
208 VAC / 3ø, 9.8A III, IV
(48.77 m)
(4536 kg)
continuous duty
230 VAC / 3ø, 9.6A
AC motor
460 VAC / 3ø, 4.8A
1 - 2 Ft / Sec
* Assumes gate to be in good condition and swinging in a level plane.
Technical Features
3/8” Steel frame
Adjustable speed control circuit: 1-2 ft/sec
Environmental: 10ºF to 140ºF (-12°C to 62°C)
1/4“ polyethylene molded cover rated NEMA 4x
Slow start / slow stop
Primary Reduction is provided by heavy-duty gear reducer
running in a continuous oil bath.
Adjustable partial open
Thermostatically controlled heater kit recommended
for colder environments
Standard speed operators use a 40:1 Reduction
Chain: includes 20’ of #80 Roller chain
Selectable stop / reverse loop function
Direct driven limit switches
Built-in power switch
Built-in 3-button control (open-close-stop)
Heavy-duty 10 ga steel housing
Warn-before-operate function
Chain tray kit (p/n 2601-270) is available in 10-ft lengths
and is recommended on gates exceeding 20-ft in length
Built-in diagnostics check for specific fault conditions
Red/Green traffic signal provides a visual indication when
the gate is safe & it is OK for traffic to proceed
Two 115 VAC Convenience outlets
Non-contact (photocells) and contact (sensing edges)
entrapment prevention devices
Shipping weight approximately 700-1,100 Lbs (317-499 kg)
Depending on model and options selected
Port for plug-in loop detectors (DKS Detectors only)
Optional Gate Tracker reporting provides operator data
to a companion DKS access control system
(models 1833, 1835, 1837 and 1838)
This vehicular slide gate operator is designed for Class
III and IV applications only and should never be used in
applications serving the general public such as apartment
complexes, gated communities, residential applications,
parking garages, etc.
External obstruction sensing devices must be used with
these operators
Distributed by:
Lee Dan Communications, Inc.
[email protected]
Toll-Free 1-800-231-1414
Access Control Solutions since 1948
120 Glasgow Avenue, Inglewood, California 90301 U.S.A.
Tel: 310-645-0023 FAX: 310-641-1586
© 2013 All Rights Reserved. Product specifications may change without notice.
Rev. 4/13
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF