VIKING E-35, -EWP handsfree video phone, C-200, C-250, C-2000B door and gate entry phone, TBB-1B talk battery booster, VE-5x5 surface mount box, VE-GNP gooseneck pedestal, DLE-200B line simulator, VCAM-1IR camera Technical Practice

Below you will find brief information for E-35, E-35-EWP. The E-35 and E-35-EWP are weather and vandal resistant handsfree video phones designed to provide quick and reliable handsfree communication and CCTV video of who is at your door or gate. The E-35 can be connected directly to a C.O. line, analog PABX/KSU station, or a Viking Door/Gate Controller: C-200, C-250 or C-2000B.

PDF Download
Document
VIKING E-35, E-35-EWP Technical Practice | Manualzz

Advertisement

Advertisement

Advertisement

Key features

  • Weather and vandal resistant
  • Handsfree communication
  • CCTV video
  • Built-in auto-dialer
  • High resolution color video camera
  • Enhanced weather protection
  • New automatic noise cancelling feature
  • Vandal resistant features
  • Weather resistant features
  • IP67 ingress protection rating

Frequently asked questions

The camera can be tilted and rotated to your desired position. A portable service (test) monitor can be used to determine the correct viewing angle during installation. Important: To prevent the edge of the faceplate from being viewed in the video image, do not rotate the camera beyond 30 degrees or tilt beyond 20 degrees.

The security code allows the user/installer to program the E-35 phone while DIP switch 3 is in the ON (normal) position. The factory set security code is 845464 (V-I-K-I-N-G). It is recommended that the factory set security code be changed.

The speed dial number programmed in location #00 is the telephone or extension number that is dialed when the “Call” button is first pressed. Additional speed dial numbers will be dialed when there is no answer or a busy signal is detected and the next number redial features are activated. The E-35 will cycle through the programmed speed dial numbers until answered. To program, enter the desired speed dial number followed by the memory location number (#00 - #04). To clear a speed dial location, simply enter the memory location (#00 - #04) alone. The E-35 is factory set with no speed dial number programmed.

There are six positions in the timing/dialing options. To program these options, enter the six desired timing/dialing digits followed by #18. The six available timing/dialing options are defined as shown below.

The E-35 can be programmed to recognize the double ring cadence that is typical of many phone systems. If the E-35 is connected to an extension that provides a double ring cadence, enabling this mode will allow for proper call progress detection.

The E-35 phone can be programmed from any Touch Tone phone using a C.O. line, analog PABX/KSU station, or a DLE-200B Line Simulator. For more information on the DLE-200B, see DOD# 605.

A speaker volume POT is provided to increase or decrease the speakerphone volume. Note: The Microphone Sensitivity POT has been removed because the microphone sensitivity is now microprocessor controlled. This allows the mic gain to be automatically increased in a quite environment, allowing the distant party to clearly hear even soft or distant sounds. The microprocessor will automatically reduce the mic sensitivity when the location becomes noisy. This Automatic Noise Canceling (ANC) feature will allow speakerphone two way communications to continue to work properly, even when subjected to loud noise such as a diesel engine or traffic.
Preparing document for printing…
0%