Phono Box S/E II Tech Data

Phono Box S/E II Tech Data
Product information
Pro-Ject Phono Box SE II
MM/MC Phono Pre-amplifier
Good sound from sound technology
Metal case shields the electronics from vibrational and electromagnetic interference
Selectable impedance for MC cartridges
Selectable load resistance for MM cartridges
Optimal channel separation through dual-mono circuitry
Subsonic filter selection switch located at the rear of the unit
Special low-noise ICs used
Gold plated RCA connection sockets
Outboard power supply included
DC operation with battery possible
Amplification and RIAA equalisation for MM and MC cartridges
Technical specifications
Input impedances, MM:
Input impedances, MC:
Output voltage:
Gain, MM:
Output voltage:
Gain, MC:
Noise floor, MM:
Noise floor, MC:
RIAA-equalisation curve accuracy:
Subsonic filter:
Outboard power supply:
Power consumption:
DC power source:
Dimensions W x H x D (D with sockets):
120, 220, 340 and 440pf/47kohm
17, 18, 20, 22, 69, 100 and 220ohms/120pF
300mV/1kHz at 3mV (MM input)
300mV/1kHz at 0,3mV (MC input)
95dB (100dB / A weighted)
75dB (80dB / A weighted)
20Hz - 20kHz / max. 0,3dB
at 18Hz with 24dB/octave
16V/1.000mA AC, suitable for your country's mains supply
DC operation with battery
16V/180mA AC
from ±12 to ±18V DC
103 x 72 x 144 (156)mm
1.050g without power supply
The manufacturer reserves the right to alter the technical specifications without notice.
Available in silver or black finish
Pro-Ject Audio Systems is a registered trademark of Heinz Lichtenegger
1050 Vienna · Margareten Road 98 · Tel. +43(0)15448580 · Fax. +43(0)15456697 · © Heinz Lichtenegger · Revision 1.6.10
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF