C3046

C3046
INSTALLATION INSTRUCTIONS
P/N C3046
82-92 Camaro/Firebird Weld-in Frame Connectors
NOTE: Transmission Crossmember must be removed before installing Frame Connectors.
1. Place a Connector in position by lining up the frame connector holes with the bolt holes for the
transmission crossmember.
2. Using the body/floor pan seam as a reference point, line the connector up so it is exactly parallel
to the seam front to back.
3. Trace connector onto the floor pan from front to back.
4. Cut floor pan away where needed.
5. When the connector is lined up in all directions, hold it in place with transmission crossmember
mount bolts. Then tack it into place and check all dimensions.
6. Weld the connector to the subframe wherever contact is made and to the floor pan where
possible.
7. Repeat this procedure for other side.
For Technical Assistance, call Competition Engineering's Tech Line at
COMPETITION ENGINEERING
(203) 458-0542, 8:30am-5:00pm Eastern Time
80 C
COMPETITION ENGINEERING
Carter Drive • Guilford, CT 06437
Phone: (203) 453-5200 • Fax: (203) 453-6906
Rev.C
082014
Visit Us At www.competitionengineering.com
C3046INST
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement