KTX-WXE-M38 Car Model Model Year INSTALLATION KIT MAZDA 3 2012 Owner’s Manual This owner’s manual will give you clearly understanding about installation. For making installation correctly, please read this manual carefully before operating installation. 1 Component Parts Audio Panel 2 Alpine-Mazda Antenna cable Alpine-Mazda power cord Bracket Connecting Diagram For other Audio connectivity please refer to the head unit Owner’s manual. Connect the connector tightly into the port. ALPINE ELECTRONICS OF ASIA PACIFIC CO., LTD. 555 Rasa Tower 1, Unit 2601-2602, 26th Floor, Phaholyothin Rd., Chatuchak, Bangkok, Thailand 10900 Tel : +662-937-0505 Fax : +662-937-0569 IN INT (Pink) Alpine-Mazda Power cord P.ANT (Blue/White) P.BRK (Yellow/Blue) http://www.alpine-asia.com 4 1 Mazda audio connector 3 Removing Vehicle Parts 5 1 A/C Console 3 Screw 2 Pcs. A/C Connector 2 !!! Caution !!! Make sure that all the accessories are off so that you do not cause a spark. 4 4 1. Remove A/C console 1 by removing 2 clips off. 2. Remove A/C connector 2 from A/C console. 3. Remove all 2 screws 3. 4. Remove all connectors 4 from the head unit. Then, remove the head unit. Harness Connection Alpine-Mazda antenna cable Antenna cable !!! Caution !!! Make connection between connectors tightly (until you hear “Click”.) 2 Power cable (24Pin) 1 Alpine-Mazda power cord Screw 2 Pcs. Connect these connectors firmly 3 Screw 4 Pcs. 1 Bracket Screw 2 Pcs. 2 Audio Panel 3 Screw 4 Pcs. 6 1. Connect the Alpine-Mazda power cord 1 into the car connectors. 2. Connect the Alpine-Mazda antenna cable 2 into the car antenna connector. Bracket Assembly 1. Install bracket 1 both left and right side of the audio panel by using 4 screws (2 screws each side). 2. Install audio panel 2 into the head unit by insert from rear side of the head unit. 3. Drive 8 screws (4 screws each side) to make it tight between bracket and the head unit. Retracing Vehicle Parts 4 A/C Console A/C Connector 2 Screw 2 Pcs. 3 Audio head unit 1. Connect Alpine-Mazda connector 1 into the head unit tightly until you hear “Click”. 2. Drive 2 screws 2 to make it tight between the head unit and car console. 3. Connect A/C connector 3 with A/C console. 4. Install A/C console 4 into car console by pressing all clips to dash panel until you hear “Click”. 1 Alpine-Mazda power cord Connect Alpine-Mazda power cord into unit 2 3 Remark Perform full function checks for the head unit. If no problem found assemble back all the parts to their original position.
* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project