MSP430-JTAG FOR PROGRAMMING AND FLASH EMULATION WITH MSP430 MICROCONTROLLERS

MSP430-JTAG FOR PROGRAMMING AND FLASH EMULATION WITH MSP430 MICROCONTROLLERS
MSP430-JTAG FOR PROGRAMMING AND FLASH EMULATION
WITH MSP430 MICROCONTROLLERS
Features:
• programs
all
MSP430Fxxx
flash
microcontrollers
• uses TI standard 2x7 pin JTAG connector
• no need for external power supply, all power
is taken from the LPT port
• compatible with IAR Kickstart software for
programming,
real
time
emulation,
debugging, step by step program execution,
breakpoints, memory dump etc everything
all high priced emulators do
• with IAR Kickstart you can write in
assembler unlimited code size and to write
in C with 2K limit for all MSP430
microcontrollers
• works with free GCC C compiler and Insight
MSP430 toolchain and debugger
• dimensions 50x40 mm (2x1.6") + 20 cm
(8") cable
Supported devices:
All MSP430Fxxx flash microcontrollers
JTAG interface:
The JTAG connector is 2x7 pin with 0,1" step
and TI recommended JTAG layout. The PIN.1 is
marked with square pad on bottom and arrow on
top.
JTAG TOP view PCB board layout:
Target microcontroller voltage:
MSP430-JTAG has build-in target board voltage
follower and the JTAG voltage levels follow
MSP430 target board voltage, so target may be
powered with voltage between 2.7 and 3.6 V (if
the target voltage is under 2.7V Flash memory
can’t be programmed)
Ordering codes:
MSP430-JTAG - assembled and tested
Copyright(c) 2002, OLIMEX Ltd., All rights reserved.
Development boards for PIC, AVR and MSP430 microcontrollers http://www.olimex.com/dev
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising