Wayne Dalton Double Flush 44 Garage Door Installation Instructions And Owner’s Manual

Below you will find brief information for Garage Door Double Flush 44. This document provides installation instructions and owner's manual for a double flush garage door model 44 with torsion rear mount low headroom. This manual provides steps to install your door, adjust the springs, and maintain your garage door.

PDF Download
Document
Garage Door Double Flush 44 Installation Instructions | Manualzz

Advertisement

Advertisement

Advertisement

Key features

  • Double Flush design
  • Torsion rear mount
  • Low headroom
  • Detailed installation instructions
  • Safety precautions during installation
  • Maintenance tips and recommendations
  • Warranty information

Frequently asked questions

Refer to the Door Section Identification section in the pre-installation to determine the correct sections to use for your door.

When installing on treated lumber, use stainless steel or PT2000 coated lag screws for center bearing brackets, end brackets, jamb brackets, drawbar operator mounting/support brackets and disconnect brackets.

The minimum side clearance required from the opening to the wall is 3-1/2" (89 mm) for a 2" track and 4-1/2" (114 mm) for a 3" track.
Preparing document for printing…
0%