advertisement
Model DLE-200B
Compatib le
Model DLE-300
Provided by
VIKING ELECTRONICS
Hudson,WI 54016 • (715) 386-8861
Visit Our Web Site: http://www.VikingElectronics.com
Telecom Solutions for the 21st Century
DLE-200B
The DLE-200B allows two-way communication between two telecom devices or systems and provides sales people with a cost effective, easy to use method of conducting
Fax Back Doc. No 605
PDF on-site demonstrations. The DLE-200B eliminates the need to locate phone lines and disrupt the customer’s phone service during product demonstrations.
This compact unit (4.75" x 2.75" x 1.38") provides 2 seconds on, 4 seconds off, interrupted 20HZ ringing and 32V talk battery to demonstrate virtually any telephone device. Compatible with modems, fax machines, answering machines and feature phones, the DLE-200B also functions as a two-way ringdown circuit.
When either telecom device goes off-hook, the DLE-200B provides
2 seconds of precise dial tone, then rings the other device until answered.
A 120V AC UL listed power supply is included.
Applications include:
• Demonstrations:
- fax machines
- modems
- phone systems
- feature phones
- any telecom device
• Classroom training
• Courtesy phones
• Elevator and emergency phones
• Inter-phone system communications
• Interfacing “ring-trip” devices:
- Dialogic or Rhetorex cards
- Dictaphone equipment
- Electronic key systems
• Distinctive ringing
• Prison phones
• Scanning documents into
P.C. based fax boards
• Fax machine repair
• Modem repair
• Communication between modems without phone lines
Ringdown Applications
FAX
Device #1
Unused C.O.
line input
KSU/PABX
Demonstrations
Device #2
1
There are different features available by changing the switch settings or by clipping the internal jumpers (see below). The DLE-200B is shipped factory set for standard applications with all features enabled.
Bottom View
Switch Settings for Distinctive
Ringing
SW-1 SW-2 RINGING CADENCE
ON ON LONG, LONG
OFF ON
ON OFF
SHORT, SHORT, LONG
SHORT, LONG, SHORT
OFF OFF 2 SECOND ON, 4 SECOND OFF
Switch #3 attenuates audio volume between devices by 9dB when in the “ON” position.
Switch 1
Switch 2
Switch 3
VIKING LABEL
2
By CLIPPING the internal jumpers on the circuit board of the
DLE-200B, the unit can:
Jumper 1:Eliminate the CPC signal.
Jumper 2:Enable only 5 rings (normally the DLB-200B continues to ring the second device until answered).
Jumper 3:Convert the unit to a ONE-way ringdown circuit. Rings from Device 1 to Device 2 only.
Jumper 4:Eliminates the two seconds of dial tone, causing the other device to begin ringing immediately.
JP4
JP3
Caution:
Personnel and work area should be grounded and power removed before handling the circuit board.
JP2
JP1
Trade Shows or Customer Demonstrations
Communicate Between Phone Systems without Using Outside Lines
KSU/PABX
By using the DLE-200B with 2 phone systems you can demonstrate the ringing on the phone systems and all the features. The DLE-200B eliminates the need to locate phone lines and disrupt the phone service during the demonstration. Demonstrations can be complete and comprehensive, but non-disruptive.
PABX
Using Dictaphone Dictation Equipment, Dialogic
Cards, etc. on Electronic Key
Many electronic key systems will not support Dictaphone dictation equipment, Dialogic cards (or any equipment that requires interaction with a Touch Tone phone) connected to the key system single line or OPX station card. Proprietary key telephones do not send Touch Tones (only data) on a station to station call.
Proprietary key telephones will send Touch Tones on outside calls.
Connect a Viking DLE-200B ringdown circuit to an unused key system line input. Then connect the Touch Tone interactive equipment to another
DLE-200B port. When a key system user selects that line position, the
DLE-200B will ring the Touch Tone interactive equipment and it can now send the Touch Tone commands.
Because the DLE-200B has much lower audio loss than a central office, the Touch Tones will be too “HOT” in most applications. They should be attentuated by setting switch 3 to the “ON” position.
Dictation equipment, dialogic cards, etc.
C.O.
Unused
Line Input
KSU/PABX
3
Sporting Events: Coach in
Pressbox to Coaches and
Players on Sideline
Eliminates Installing Phone Lines!
For Dedicated Communication Between 2 Phones
Eliminates the Need for
Station Circuits, Phone
Systems or C.O. Lines
• Prison Phones
• Courtesy Phones
• Infra and Inter-Office
Communications
• Warehouses
• Elevator Phones
Up to 2 miles
Communicating Between 2 Different Computers
The DLE-200B will allow 2 different types of computers to communicate with each other utilizing your communication software. Two (2) seconds of precise dial tone (required by most modems) is provided.
4
Macintosh IBM
Hotel Check-out Time
Let Your Customers Use a Phone to Pick Up Their Car
Instead of lining up at the lobby desk to pick up their cars, have guests pick up a phone which connects to the parking area. By using Viking’s
Model K-1500P-W wall phone or the K-1500P-D desk phone with the
DLE-200B you can accomplish just that. The DLE-200B detects the offhook on the courtesy
Hotel parking lot. How may
I help you?
phone and sends ringing to the phone connected to the other port until answered.
Hotel desk staff are
Valet parking courtesy phones
K-1500P-W (wall) or K-1500P-D (desk) then free to take care of guests who are checking in and checking out, resulting in improved guest services. Great for hotels where large convention crowds check-in and check-out en masse.
Emergency Phones
When the button on the Viking E-10/20A/30 emergency phone is pressed, the DLE-200B provides ringing to the security phone.
Parking lot
Security. How may
I help you?
Help! I’ve fallen and I can’t get up!!
E-30
5
Communicate from the 18th Hole...
...to the Clubhouse Restuarant
In this application your food and beverage can be ready when you come in from the eighteenth green. Just press and hold the button (when using E-15) on the E-10, E-15 or E-20A, activating the DLE-200B, providing ringing into a phone in the restaurant connected to the DLE-
200B. Place your food order and by the time you get to the restaurant your food will be ready.
Clubhouse
Restaurant
E-10, E-15,
20A or E-30
Elevator or Emergency Phones
By using the DLE-200B with elevator phones an extra phone circuit is not needed. Plug the elevator phone into one of the ports on the
DLE-200B and the security phone into the other port. When used with a conventional phone in an elevator application, the DLE-200B eliminates the risk of long distance fraud.
E-1600A
E-1600-EHFA
6
Security Office
Demonstrate the Features of Fax Machines,
Answering Machines, Feature Phones, Modems, Key
Systems, PABX’s or any telecom device
Eliminates Disrupting your Customer’s Phone Lines.
Fax, modem, etc.
Fax, modem, etc.
The DLE-200B will provide CPC when demonstrating answering machines.
Training:
• Classroom
• Telemarketing
• Hostage Negotiating
• Attendant/Receptionist
The DLE-200B is used to provide the realistic telephone circuit desired for training of this type.
7
Demonstrate Custom Ringing
Demonstrate the FAXJ-300 and PDF-2 Custom Ringing Detection
The DLE-200B can generate 4 different distinctive ringing patterns.
The FAXJ-300 or PDF-2 must be set to the custom ring detection mode by setting the proper switches (see the appropriate Tech Practices).
The following chart shows the ringing patterns generated for each switch setting on the DLE-200B and the port the call will be directed to on the
FAXJ-300 or PDF-2.
Switch Settings on the DLE-200B
SW-1 SW-2
OFF OFF
ON
OFF
ON
OFF
ON
ON
Ring Pattern Generated by the DLE-200B
2 SECOND “ON”
4 SECOND “OFF” (NORMAL)
SHORT, LONG, SHORT
SHORT, SHORT, LONG
LONG, LONG
Port the Call will be directed to By:
FAXJ-300 PDF-2
PHONE PHONE
NONE
NONE
DATA
MODEM
MODEM
FAX
Set switches 2 and 3 to the “ON” position.
Press the “TR” button on the FAXJ-300.
ON
X-N.A.
(switches are on the bottom)
Single Line
Device
Single Line
Telephone
Fax Machine Single Line
Telephone
8
Set switches 2 and 4 to the
“ON” position and switch 3 to the “OFF” position.
Press the “RESET” button on the PDF-2.
O
N
1 2 3 4
X-N.A.
Single Line
Device
Single Line
Telephone
Modem
Fax Machine
Use your Fax Machine as a Full Page Scanner for your Fax Board
Fax Machine
Fax Board
(Modem)
9
Features:
Fax Back Doc. No 607
DLE-300
The DLE-300 advanced Line
Simulator provides sales people, technicians, engineers, etc. with a cost effective, easy to use method of conducting on-site demonstrations or diagnostics, eliminating the need to locate phone lines and disrupt the customer’s phone service.
The Line Simulator provides two way communication between standard analog telecom products such as modems, fax machines, Key
Systems, PABX’s as well as standard
• Supports all high speed data
• Produces name and number caller ID data
• Audio input/output for recording voice prompts
• 40V DC talk battery
• Precise call progress tones (dial tone, ringback, busy and reorder)
• Produces special interrupt tones
• Standard and distinctive 20 Hz
AC ringing
• Provides CPC breaks after disconnect
• Touch Tone detection
• Ringdown mode (no Touch
Tones required)
• 911 trainer mode for classroom training
• One year warranty telephones.
The DLE-300 Line Simulator produces standard or distinctive AC ringing, DC talk battery, caller ID data, precise dial tone, ring back, busy,
SIT, reorder tone, and provides CPC on disconnect.
Installation/Applications
A. Demonstrations and Classroom Training
The DLE-300 is ideal for on-site product trainings at trade shows and perspective customer sites. It can also be configured as a 911 trainer for classrooms, etc.
Up to 2.6 miles
10
13.8V AC
Adapter
(provided)
Powered
Speaker
(not included)
B. High Speed Data Communication
The DLE-300 will support the data speeds of your supporting peripherals.
Up to 2.6 miles
Personal Computer
13.8V AC
Adapter
(provided)
Personal Computer
Important: A UPS/surge protector is recommended. The DLE-300 is NOT protected from power surges and will not operate during power failures.
C. Programming and Recording Voice Mail Systems and Other Voice Products.
Using the AUDIO input jack, the DLE-300 can be used to program and record nearly any voice related product.
PABX/KSU
13.8V AC
Adapter
(provided)
Voice Mail System
Tape Player
11
D. Point to Point Communication
The DLE-300 can be configured as a ringdown circuit for instantaneous point to point telephone communications.
Up to 2.6 miles
13.8V AC
Adapter
(provided)
mportant: A UPS/surge protector is recommended. The DLE-300 is NOT protected from power surges and will not operate during power failures.
Internal Jumpers
Removing internal jumpers may be used to disable specific features
(see diagram).
1. CPC signal
Remove shunt JP1 to disable
CPC signal.
2. Caller ID
Remove shunt JP2 to disable all
“Caller ID” data.
DLE-300 Circuit Board
3. Ring Count
Remove shunt JP3 to disable the maximum ring count.
4. Reorder
Remove shunt JP4 to change the
10 seconds of reorder tone (fast busy) that are given when the other phone hangs up, to 10 seconds of continuous dial tone.
5. Attentuation
The two device ports are directly connected together offering no signal loss between the devices. Move shunt from JP5 to JP6 to attentuate the audio volume between the devices by 9 db (typical of most C.O. lines).
12
JP5
JP6
JP1
JP2
JP3
JP4
2-Way Ringdown Circuits/Line Simulators
Provide Point-to-Point Communication
Model DLE-200B
Model DLE-300
Fax Back Doc. No 605
Fax Back Doc. No 607
Shockwave Demos
On-Line.
To receive a complete Product Catalog or Free Helpful Guides call or E-mail us!
Other Free Helpful Guides:
ADA Guide In Plain English
Fax Back Doc. No 842
Digital Announcers
Buyers Guide
Fax Back Doc. No 841
Access Control/Door Entry
System Buyers Guide
Fax Back Doc. No 846
Provided by
VIKING ELECTRONICS
Hudson,WI 54016 • (715) 386-8861
Visit Our Web Site: http://www.VikingElectronics.com
Telecom Solutions for the 21st Century
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Related manuals
advertisement