MSDS MO-JO

MSDS MO-JO
MSDS - MO-JO - Created on 2/6/2013 12:43:00 PM
Product: MO-JO
Product No. MJ55
MATERIAL SAFETY DATA SHEET
Date: 2/6/2013
Supersedes: NEW
COMPANY:
Envirospec
751 MLK Highway
Homerville, GA 31634
(Div. of Hi-Tech Jetting Technologies, Inc.)
Prepared By: JA
INFORMATION: 1-800-346-4876
EMERGENCY: 1-800-424-9300
(Chemtrec)
GENERAL:
(912) 487-1778
SECTION 1: GENERAL INFORMATION
Product Name:
Class:
Shipping Name:
Hazard Class:
UN/NA#:
MO-JO
ALKALINE CLEANING COMPOUND
COMPOUND CLEANING SOLID
NA
NA
Precautions: DANGER Causes eye, skin and respiratory tract irritation. Avoid eye and skin contact. Wash thoroughly
after handling. Avoid breathing mist. Use adequate ventilation.
Ingredients (CAS #)
SECTION 2: HAZARDOUS INGREDIETS
%Wt
1. Silicic Acid, Disodium Salt (6834-92-0)
2. Sodium Tripolyphosphate (7758-29-4)
3. Nonylphenolpolyethoxyethanol (127087-87-0)
4. Sulfur-containing polyalkylene oxide
40-70
10-40
1-10
1-05
OSHA PEL ACGIH TLV
(ppm or mg/M3)
NA
NA
NA
NA
NA
NA
Not Established Not Established
NOTE: Several Non-Caustic & Environmentally Sound ingredients are being withheld as “Trade Secrets” as afforded
by law and in accordance with Comment (b) to 757 the Restatement of the Law of Torts.
SECTION 3: HEALTH HAZARD DATA
OCCUPATIONAL EXPOURE LIMITS: Carcinogenicity: NTP: No IARC: No OAHS: No
EFFECTS OF OVER EXPOSURE:
Ingestion:
Damage to renal system may occur
Eyed:
Causes severe eye irritation
Skin:
Causes skin irritation
Inhalation:
Causes respiratory tract irritation
EMERGENCY FIRST AID PROCEDURES:
Ingestion: Dilute the alkali by giving water or milk immediately and allow vomiting to occur. Examine victim for
possible corrosive injury to mouth and throat and irrigate the areas with 1% Acetic Acid until alkali is completely
neutralized. Avoid gastric lavage or emesis. (Dreisbach, Handbook of Poisoning, 11th Edition). Maintain airway and
treat shock. If vomiting occurs, keep head below hips to help prevent aspiration. Get medical attention immediately.
Eyes: Flush with copious amounts of water until all material is removed. If irritation develops or persists get medical
attention.
Skin: Thoroughly wash exposed area with soap and water. Remove contaminated clothing. Launder contaminated
clothing before reuse.
Inhalation: Remove to fresh air. If breathing is difficult, oxygen may be given, preferably with a physician’s advice. If
not breathing, give artificial respiration, preferably mouth-to-mouth. Get immediate medical attention.
Page 1 of 2
MSDS - MO-JO - Created on 2/6/2013 12:43:00 PM
SECTION 4: FIRE & EXPLOSION HAZARD DATA
FLASH POINT: NA
FLAMMABLE LIMITS: NA
AUTO IGNITION TEMPERATURE: NA
EXTINGUISH MEDIA: Use water spray, dry chemical, CO2, or “alcohol” foam
SPECIAL FIREFIGHTING PROCEDURES: Firefighters should be equipped with self-contained breathing apparatus
with full-face piece operated in pressure demand or other positive mode.
SPECIAL FIRE & EXPLOSION HAZARDS: Combustion may produce noxious and irritating gases which will require
fresh air source in fire fighting.
SECTION 5: PHYSICAL DATA
BOILING POINT:
NA
SPECIFIC GRAVITY:
NA
VAPOR PRESSURE:
NA
MELTING POINT:
NA
VAPOR DENSITY:
NA
EVAPORATION RATE:
NA
SOLUBILITY IN WATER: Complete
APPEARANCE:
LIGHT BROWN POWDER
ODOR:
CINNIMON
SECTION 6: REACTIVITY DATA
STABILITY: Stable
CONDITIONS TO AVOID: Heat, flames and contact with strong oxidizing agents
INCOMPATIBILITY (MATERIALS TO AVOID): Strong acids, strong oxidizers and excessive heat
HAZARDOUS DECOMPOSITION PRODUCTS: Carbon Monoxide, Carbon Dioxide and other toxic gases
HAZARDOUS POLYMERIZATION:
SECTION 7: SPILL, LEAK & DISPOSAL PROCEDURES
STEPS TO BE TAKEN IN CASE MATERIAL IS RELEASED OR SPILLED: Shovel product directly
into recovery drums. If material is released into the environment, the user should determine whether the
release should be reported to the appropriate state and federal authorities based on the requirements in your
local area.
WASTE DISPOSAL PROCEDURES: Consult local, state and federal regulations before disposing of this material.
SECTION 8: SPECIAL PROTECTION INFORMATION
RESPIRATORY PROTECTION (SPECIFIC TYPE): The specific respirator selected must be based on the
contamination level found in the work place
VENTILATION: Either local exhaust or process enclosure ventilation system.
PROTECTIVE GLOVES: Depending on the condition of use, protective gloves, apron, boots, head and face
protection should be cleaned thoroughly after use.
EYE PROTECTION: Employee should wear splash proof or dust resistant goggles and a face shield to prevent
contact with this material. Contact lenses should not be worn.
OTHER PROTECTIVE EQUIPMENT: Emergency eye wash fountains and safety showers should be available in
the immediate vicinity of any potential exposure.
SECTION 9: SPECIAL PRECAUTIONS
PRECAUTIONS TO BE TAKEN IN HANDLING AND STORING: Store away from acids and strong oxidizers. Do
not transfer to unmarked containers.
OTHER PRECAUTIONS: Eyewash & safety shower in work area.
Page 2 of 2
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement