ASA Electronics MXA6BA Guide
advertisement
MXA6BA Troubleshooting Guide
Unit will not turn ON
• Check fuse.
• Verify wiring is correct as described in manual.
• Verify you have 12V+ DC on the Yellow power wire.
• Check Ground.
• Check remote trigger wire is connected (REM) and receiving 12V+DC when necessary.
• Confirm the Deutsch connector is seated properly.
No Sound
• Check Volume, Balance, Fader & Mute controls on stereo for proper settings.
• Check to make sure audio signal is connected to amp’s input (either Speaker
Level or Low Level).
• Check Level, Crossover & Mode settings on amp are correct, as described in manual.
Distorted Sound
•
See if distortion is present at all volume levels; if so, test with a known good speaker.
•
If distortion only present at high volume levels, adjust volume and amp Level controls until distortion no longer present.
Blows Fuses
• Power wires are backwards. Correct wiring as shown in manual.
Internal problem with amp. Contact vendor for warranty assistance.
•
Poor Bass Response
• Speakers out of phase. Check for correct speaker polarity.
B. Woods
Tech Services
05.01.07
advertisement
Related manuals
advertisement
