C7046

C7046
INSTALLATION INSTRUCTIONS
P/N: C7046
BOLT-ON WHEEL-E-BAR CONVERSION KIT
These Bolt-on Wheel-e-bar Conversion Brackets replace the existing axle mounting
brackets found in Competition Engineering Wheel-e-Bar Kits P/N’s C2016, C2039,
and C2040.
Installation
Bolt the new brackets to your wheel-e-bar using the original fasteners provided. With
the car on a level surface, position the wheel-e-bars under the car with the brackets
resting up against the housing. Then prop them up so the wheels are 6” off the ground
for street use. In this position, fasten the housing saddle brackets over the rear end
housing using the 1/2-20 Nylock nuts provided.
If the rear end housing brackets are too big for your particular housing, the housing
saddle bracket can be welded to the housing and the rear end bracket bolted to it.
Thereby allowing the wheel-e-bars to be removed from the car.
Note: The Axle Housing must be clean and free of welding slag, etc. in the vicinity
where the housing brackets will be located to insure a firm grip of the bracket and strap
on the housing.
For Technical Assistance, call Competition Engineering's Tech Line at
(203) 458-0542, 8:30am-5:00pm Eastern Time
COMPETITION ENGINEERING
80 Carter Drive • Guilford, CT 06437
Phone: (203) 453-5200 • Fax: (203) 453-6906
REV. B
082614
Visit Us At www.competitionengineering.com
C7046INST
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement