STANLEY LO21B/U MAGIC FORCE Automatic door opener Installation and operation instructions

The STANLEY LO21B/U MAGIC FORCE is an automatic door opener designed for use with the PARALLAX 2 system. It features a quick disconnect cable on the approach side for easy installation and maintenance. The system also includes a safety/stall feature that prevents the door from opening if the breakout switch is not installed correctly.

PDF Download

Document

BODYGUARD

LEFT APPRCH SIDE SSCAN RIGHT APPRCH SIDE SSCAN LEFT SAFETY SIDE SSCAN RIGHT SAFETY SIDE SSCAN

24 V

TRANSFORMER

EAGLE

N.C. 5

N.O. 4 green

COM 3 white

POWER 2 black

POWER 1 red

SUPERSCAN QUICK

DISCONNECT CABLE

SUPERSCAN QUICK

DISCONNECT CABLE

HOLD OPEN

YELLOW

OFF

ORANGE

VIOLET

AUTO

COM

N/O

N/C

MAGIC FORCE

AUXILIARY

SWITCH #4

(SEE NOTE #1)

COM

N/O

N/C

MAGIC FORCE

AUXILIARY

SWITCH #4

(SEE NOTE #1)

1 COMMON

2 OPERATE

3 SENSOR OP

4 12 VAC

5 12 VAC

6 AUX INPUT

7 SAFETY/STALL

8 COMMON

STANLEY MP

CONTROL

INSTALL JUMPER

IF NO BREAKOUT

SWITCH.

RED

GREEN

LO21 B/U

BLUE

YELLOW

OFF

GREEN

BLACK

RED

MOTOR

MOTOR VOLTAGE (AT MOTOR)

(SEE NOTE #2)

NOTES: 1 ) MAGIC FORCE AUX. SWITCH #4 SHOULD OPEN AT APPROX. 65-70 DEGREES. FOR MAGIC SWING REFER TO INHIBIT SWITCH BEA PT# 10 SSINHL OR 10SSINHR

2 ) SHOWN LH,RH MAGIC SWING AND RH MAGIC FORCE FOR LH MAGIC FORCE REVERSE RED AND BLACK LO21B/U WIRES.

3 ) DOOR CONTROL SW2 SWITCH BANK SET DIPSWITCH # 1 & 3 TO THE OFF (TIMER) POSITION.

4 ) LO21U DIPSWITCHES: 1-5 (LOCK-OUT TIMING), #6 (DOWN/ON). #7 (UP/OFF), #8 (DOWN/ON)

IF AFTER TROUBLESHOOTING A PROBLEM, A SATISFACTORY SOLUTION CANNOT BE ACHIEVED, PLEASE CALL B.E.A., INC. FOR FURTHER ASSISTANCE DURING EASTERN STANDARD TIME

AT 1-800-523-2462 FROM 8AM - 5PM. FOR AFTER-HOURS, CALL EAST COAST: 1-866-836-1863 OR 1-800-407-4545 / MID-WEST: 1-888-308-8843 / WEST COAST: 1-888-419-2564. DO NOT LEAVE

ANY PROBLEM UNRESOLVED. IF YOU MUST WAIT FOR THE FOLLOWING WORKDAY TO CALL B.E.A., LEAVE THE DOOR INOPERABLE UNTIL SATISFACTORY REPAIRS CAN BE MADE. NEVER

SACRIFICE THE SAFE OPERATION OF THE AUTOMATIC DOOR OR GATE FOR AN INCOMPLETE SOLUTION.WEB: WWW.BEASENSORS.COM

100 ENTERPRISE DRIVE

PITTSBURGH, PA 15275

PHONE: (412) 249-4100

FAX: (412) 249-4101

EMAIL: www.beasensors.com

TITLE: STANLEY MAGIC FORCE WITH

PARALLAX 2 SYSTEM (LO21B/U),

Q-DISCONNECT ON APPROACH SIDE

SIZE:

DRAWN BY:

KJG

SCALE:

NONE

REV BY:

WJR

DATE:

09 FEB 2010

PART NO:

SHEET

1 OF 1

80.0170.02

Hello! I am an AI chatbot specifically trained to assist you with the LO21B/U MAGIC FORCE Automatic door opener Installation and operation instructions. I have thoroughly reviewed the document and can help you locate the exact information you need or explain the content in clear and simple terms. Whether you’re looking for guidance on specific features, troubleshooting steps, or general usage, feel free to ask your questions. The more details you provide about your concerns or needs, the more accurately and effectively I can assist you!

Show related prompts

Assistant typing

Assistant terminated

Key features

Quick disconnect cable
Safety/stall feature
Easy to install
Reliable operation
Compatible with PARALLAX 2 system
Magic Force auxiliary switch
Magic Swing inhibit switch
LO21B/U control unit
SuperScan quick disconnect cable

Frequently asked questions

The Magic Force auxiliary switch should open at approximately 65-70 degrees. It is used to prevent the door from opening if it is not fully closed.

The SuperScan quick disconnect cable is used to make it easier to disconnect the door opener from the control unit for maintenance or repairs.

The LO21B/U control unit should be installed in a dry, well-ventilated location. Refer to the installation instructions for specific details.

The safety/stall feature prevents the door from opening if the breakout switch is not installed correctly. This helps to prevent accidents and injuries.