2501 Ludelle Street
Fort Worth, Texas 76105
817-244-6212 Phone • 817-244-4024 Fax
888-350-6588 Sales • 800-423-9696 Tech
E-mail: [email protected]
Web: www.painlessperformance.com
30100
UNIVERSAL 70 AMP FAN RELAY
INSTALLATION
1) MOUNT THE RELAY UNDER THE HOOD IN A CONVENIENT LOCATION AS
CLOSE TO THE FAN AS POSSIBLE, MAKING SURE THAT THE BLACK WIRE
IS WELL GROUNDED.
2) USING THE BLUE BUTT CONNECTOR SPLICE THE SMALL GRAY/WHITE WIRE
TO THE WIRE FROM THE FAN SWITCH, YOU CAN ALSO ROUTE THIS WIRE
DIRECTLY TO THE IGNITION SWITCH IF YOU WANT THE FAN(S) TO COME AND
GO OFF WITH THE IGNITION SWITCH.
3) ROUTE AND CONNECT THE RED WIRE LABELED “TO FAN MOTOR”, TO THE
FAN "+" TERMINAL OR POWER WIRE COMING FROM THE FAN MOTOR.
NOTE: WITH THIS RELAY YOU CAN OPERATE A FAN RATED UP TO 70
AMP'S OR TWO FANS AS LONG AS THE TOTAL CURRENT DRAW
FOR BOTH IS LESS THAN 70 AMP'S.
4) NEATLY ROUTE THE OTHER RED WIRE TO THE POWER SOURCE, SUCH AS
THE MAXI FUSE, CUT TO LENGTH AND INSTALL USING A SMALL YELLOW
RING TERMINAL.
5) TEST THE RELAY FOR PROPER OPERATION.
NOTE: DUE TO HOUSING DESIGN, THE RELAY MAY NOT APPEAR TO
BE FULLY SEATED IN THE BASE. A GAP OF UP TO 1/16 INCH IS
NORMAL
1
2
Painless Performance Limited Warranty
and Return Policy
Chassis harnesses, fuel injection harnesses and Striker Coldshot are covered under a lifetime warranty. All other products manufactured and/or sold by Painless Performance are warranted to the original purchaser to be free from defects in material and workmanship under normal use. Painless Performance will repair or replace defective products without charge during the first 12 months from the purchase date. No products will be considered for warranty without a copy of the purchase receipt showing the sellers name, address and date of purchase. You must return the product to the dealer you purchased it from to initiate warranty procedures.
Copyright
© 2007 by Perfect Performance Products, LLC
3
