Datenblatt MSP430

Datenblatt MSP430
MSP430-JTAG FOR PROGRAMMING AND FLASH EMULATION
WITH MSP430 MICROCONTROLLERS
Features:
MSP430-JTAG connects to LPT parallel port
and works with IAR KickStart software.
KickStart allow you to write and debug code in
assembly language without any limitations and to
write code in C with 2K limit for all MSP430
microcontrollers. The latest release of KickStart
software may be free download from TI web site:
http://www.ti.com/sc/msp430
MSP430-JTAG doesn’t need external power
supply, as MSP430 microcontrollers require only
3-5 mA while programming and all necessary
power supply is taken from the LPT port.
JTAG TOP view PCB board layout:
Supported devices:
The currently supported devices, which can be
programmed with MSP430-JTAG are:
Target microcontroller voltage:
MSP430-JTAG has build-in target board voltage
follower and the JTAG voltage levels follow
MSP430 target board voltage, so target may be
powered with voltage between 2.7 and 3.6 V (if
the target voltage is under 2.7V Flash memory
can’t be programmed)
MSP430F1101, MSP430F1121, MSP430F111,
MSP430F112,
Ordering codes:
MSP430-JTAG - assembled and tested
MSP430F121, MSP430F122, MSP430F123,
MSP430F133, MSP430F135, MSP430F147,
MSP430F148, MSP430F149,
MSP430F412 and MSP430F413.
JTAG interface:
The JTAG connector is 2x7 pin with 0,1" step
and TI recommended JTAG layout. The PIN.1 is
marked with square pad on bottom and arrow on
top.
Copyright(c) 2002, OLIMEX Ltd., All rights reserved.
Development boards for PIC, AVR and MSP430 microcontrollers http://www.olimex.com/dev
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising