Quick Grille Release Kit
www.genosgarage.com
UNDERHOOD
RAM
Installation: ‘10-current
Quick Release Grill Kit
Grill Removal
1) Remove the four (4) plastic push pins that hold the “Heavy Duty” plastic cooling cowl in its place.
You’ll need to salvage two of the four plastic pins.
2) Lift the “Heavy Duty” plastic cooling cowl from the radiator core support and set it aside.
If you need more assistance, we are only a phone call away.
(770) 886-2500
Monday–Friday
8:30am–5:30pm EST
GENO’S GARAGE, INC.
1150 Samples Industrial Drive
Cumming, Georgia 30041
UNDERHOOD
PAGE 2
www.genosgarage.com
RAM
Installation: ‘10-current
Quick Release Grill Kit
3) Remove the four (4) 10mm coarse threaded bolts that hold the grill in place.
FOR 2010-2012 OWNERS:
4A) The bottom of the grill is held in place with a metal clip on each side. Lift the grill 1/8” vertically
and then pull the bottom of the grill out horizontally.
FOR 2013-NEWER OWNERS:
4B) The grill is held in place with two metal clips on each side. You can release the metal clips (top
first, then bottom) with a flat blade screwdriver or lift and pull it out horizontally.
UNDERHOOD
PAGE 3
www.genosgarage.com
RAM
Installation: ‘10-current
Quick Release Grill Kit
Grill Modifications
5) Remove the metal clips from the (two on the 2010-2012; all four on the 2013-newer) grill. These
clips will not be reused – it is okay to mangle and twist them during the removal process.
Cowl Modifications
6) Reinstall the grill. With the grill loosely in place, using a 1/4” drill bit, drill out the two “outpost”
holes in the grill as well as the plastic that is below the outpost holes. This is done because the size
of the factory hole is slightly too small for the pins that will replace the original screws.
UNDERHOOD
PAGE 4
www.genosgarage.com
RAM
Installation: ‘10-current
Quick Release Grill Kit
2
1
7) Reattach the plastic “Heavy Duty” cooling cowl with the two salvaged plastic push pins.
Grill Installation
B
A
8) With the grill and “Heavy Duty” cowl assembly in position, drop the pins into the outpost
holes (A) and (B).
UNDERHOOD
PAGE 5
www.genosgarage.com
RAM
Installation: ‘10-current
Quick Release Grill Kit
9) With a 5/16” socket and electric drill, drill the self-tapping 5/16” sheet metal screws through the
pin hold-downs and into the truck’s front quarterpanel sheetmetal.
10) Close the hood. You’ve finished installing the Quick Release Grill Kit in your Turbo Diesel.
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement