PG Conversion Kit

PG Conversion Kit
O-Ring
PG C ONVERSION K IT
HS9385NPT
I N S TA L L AT I O N
AND
O P E R AT I N G I N S T R U C T I O N S
1
INSTALLATION
Remove the standard NPT wire grip by loosening the three
M4 screws that hold it in place. Remove the purple O-ring
from the NPT wire grip and install it over the PG wire grip.
Install the PG wire grip by inserting it into the base assembly
and aligning the three holes in the rail assembly with the
three holes in the wire grip. Insert and tighten the three M4
screws.
HS9385NPT: English-to-metric fitting for use with
HS9385 Series Housings.
Item
PG Wire Grip
Quantity
1
Tools
M3 (3 mm) Hex Wrench.
NPT Wire Grip
O-Ring
M4 Screws
PG Wire Grip
O-Ring
M4 Screws
Rail Assembly
Base Assembly
Figure 1: Installing the HS9385NPT
©2002 Aigis Mechtronics
1124 Louise Road,Winston-Salem, NC 27107-5450
Tel: 336.785.7740 Fax: 336.785.7744
Data subject to change without notice
100 0032 001 AIG 10/02
Printed in U.S.A.
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement