Husky Liners Installation Instructions 56431

Husky Liners Installation Instructions 56431
PART NO.
5643
02-03 EXPLORER WITH CK RUNNING BOARD FRONT MUD GUARD SET
FRONT MUD GUARD INSTALLATION INSTRUCTIONS
Please read instructions thoroughly before installation.
Tools Required:
• 1/8” drill bit / Drill
• Center punch / Hammer
• Short Phillips screwdriver
• Marking utensil (fine tip marker, grease pencil, etc.)
•
•
•
•
•
Package Contents
Driver & passenger side mud guard
1” #10 screws (qty. 8)
Washers (qty. 2)
U-clips (qty. 2)
Instruction sheet
NOTE: Turn the front wheels all the way to the left or right for mud guard installation. However, it may be necessary
to remove the wheels depending on the tools being used for installation.
1. Clean and degrease the mud guard location area on the fender before installation.
2. Remove existing fastener from location A (see Figure 1).
3. Attach mud guard to fender with a #10 screw and washer thru mud guard, fender, and into a U-Clip placed on the
backside of fender (see Figure 2), check to make sure mud guard is evenly covering tire and is parallel to the
ground.
4. Using mud guard as a template, mark, center punch, and drill 1/8” holes at locations B, C & D (Figure 1).
5. Attach mud guard to fender with 1” #10 screws at locations B, C, & D.
PAINTING INSTRUCTIONS
1. Clean mud guard with a soap and water solution to remove dirt and other contaminates.
2. Sand painting surface with 320 grit sand paper.
3. Apply a coating of flexible primer-adhesion promoter.
4. Apply a flexible paint as directed by the paint manufacturer
5643 Front Instructions.doc
Rev: 0
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement