CANNON 12 LED ™ MADE IN THE U.S.A. Installation and Operational Guide

CANNON 12 LED ™ MADE IN THE U.S.A. Installation and Operational Guide
CANNON 12 LED™
MADE IN THE U.S.A.
Installation and Operational Guide
Screw
This manual serves as a guide for the Cannon LED™ hide-a-way.
Automotive Lamp Installation Instructions:
Flange
In this installation method, the Cannon LED will share the same reflector as the taillight, headlight
or brake light. Make sure the Cannon LED does not interfere with the operation of these lights. The
Cannon LED is designed to function with its inline driver.
1. Follow OEM instructions on how to remove the headlight or taillight
reflector assembly from the vehicle.
2. Locate a flat surface in the bottom of the housing and cut a 1” diameter
hole in the housing with the use of a hole saw. Make sure to de-burr the hole
thoroughly.
Gasket
3. Place the Cannon LED into the reflector housing and mark the spot for the
two mounting holes. Remove the Cannon LED and drill two, 2 mm holes.
4. Insert the Cannon LED from the back or bottom of the headlight/taillight,
as close to the focal point as possible.
Lighthead
5. Screw in the Cannon LED using the provided hardware and secure it to the
reflector assembly.
6. Remount the headlight or taillight assembly in the vehicle and follow the
provided wiring instructions.
WIRING DIAGRAM
Note: Mode 2 overrides mode 1 and mode 3 overrides mode 2 and 1.
Wiring Instructions:
1. To activate the unit,extend the red (+), yellow (+) or green (+) wire to a 12V
post. Extend the black (-) wire to the ground post of the vehicle’s battery.
360° Spread
120° Spread
2. Momentarily connect the blue wire to the Ground (12V-) to cycle through
the flash patterns.
3. Synchronization: To Sync two or more light heads together:
A. Apply 12V+ power to the the red (+) yellow (+) or green (+) wire and apply
12V- to the black wire to power the unit on.
120°
B. Cycle through all patterns by tapping the blue (flash pattern changer) wire to
the activated black, ground wire until the steady burn pattern is selected.
360°
C. Connect one of the same colored mode wires (red, yellow or green) of the
two light heads together; connect the black wires of the light heads together
and then connect the blue wires of the light heads together.
Alternate Light Heads:
D. Follow Steps A-B
E. For the light heads to alternate, one light head must be set as master and the
other as slave. To do so, hold the blue (flash pattern changer) wire to ground for
3 seconds. If all LEDS turn on this indicated master mode. If half the LEDs
activate this indicates slave mode.
F. Follow Step C. Change patterns by tapping the blue wire to the activated
black, ground wire.
Color:
Red
Blue
Wire:
Red:
Yellow:
Green:
Blue:
Black:
Amber
Function:
Positive, Mode 1
Positive, Mode 2
Positive, Mode 3
Flash Pattern Changer/Sync
Negative, Ground
White
Green
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement