C3030

C3030
INSTALLATION INSTRUCTIONS
TUBULAR DRIVESHAFT SAFETY LOOP/KIT
P/N: C3030
This kit is designed to offer a lightweight, weld-in alternative to the bolt-on driveshaft safety
loop. It can also be used as a universal mount for various applications.
PARTS LIST
(1) Mandrel-formed Loop
(2) Loop Mounting Stubs
(2) Snap Pins
INSTALLATION:
1. Determine the proper mounting location for the Loop in a Driveshaft Safety Loop application
where there is an existing crossmember. We recommend placing it a maximum of 6” from the
universal joint in place.
2. Hold the hoop in place and mark the legs for trimming. Keep in mind that you will need 2-1/2”
of clearance at the top of the hoop to allow its removal from the mounting stubs.
3. Trim the legs of the hoop to length.
4. Slide the mounting stubs into the ends of the hoop. Place the hoop in position on the
crossmember and tack the stub ends to the crossmember. Remove the hoop and finish the
weld.
5. Re-install the hoop and drill through the hoop legs and stubs using an 11/32” drill bit.
6. Install the supplied 5/16” bolts and locknuts, using a washer on each side of the hoop.
For Technical Assistance, call Competition Engineering's Tech Line at
(203) 458-0542, 8:30am-5:00pm Eastern Time
COMPETITION ENGINEERING
Rev. D
122012
80 Carter Drive • Guilford, CT 06437
Phone: (203) 453-5200 • Fax: (203) 453-6906
Visit Us At www.competitionengineering.com
C3030INST
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement