Crescendo 10.1 plus System Instructions

Crescendo 10.1 plus System Instructions
Problems and Cures
Crescendo 10/1 Plus
WARNING :
The sound output levels from this system can be very high. It is
recommended that the volume control should be turned to the "OFF"
position before changing batteries or plugging or unplugging the
headphones or microphone.
Instructions for use
1. Plug the microphone into the socket marked <MIC> and the headset into the socket
marked <PHONES>.
2. Attach the microphone to the television speaker grille using one of the self-adhesive
Velcro pads supplied. Peel off the backing paper and press the pad firmly in place. The
Velcro already on the microphone will then fasten to the pad if lightly pressed in place.
To remove the microphone, pull it away gently. The microphone may be used on other
equipment such as a radio or Hi-Fi.
3. Set the television to the normal listening level for the other members of your household
and turn the Crescendo's volume control clockwise until the desired headset volume is
reached. Remember to switch off the amplifier when not in use by turning the knob
fully anti-clockwise, when a "click" will be felt.
Problem
No Sound
Cure
• Headset & microphone in wrong sockets - change round.
• Battery exhausted - fit new battery.
Low or distorted sound
• Battery almost exhausted -fit new battery.
• Headset blocked with wax - clean headset ends or fit new
forkends
Buzz or squeal after short • Battery almost exhausted, system will seem OK when first
time
switched on - fit new battery
Crackling or
• Dirty microphone plug - clean plug.
Sound goes on & off
• Faulty headset or microphone lead - wiggle lead by plug to
find faulty lead, replace lead.
If in doubt please contact your dealer for assistance.
The headset ends can be removed for cleaning and removal of wax. They can be washed in
warm soapy water but must be thoroughly dried before replacing.
If the system needs to be returned for repair please send the complete system including the
amplifier, headset and microphone.
Please state the nature of the fault and the return address. If the system is still under
guarantee please state this and provide proof of purchase.
The product should give a long and trouble-free service if the following points are observed.
• Treat the headset and microphone leads carefully, they are quite thin in order to be
convenient and comfortable to use.
• DO NOT wrap the leads around the amplifier.
• DO NOT leave the microphone lead trailing across the floor to be tripped over.
Battery Changing
To change the battery in the amplifier, turn it over and whilst pressing down, slide the
battery cover in the direction of the arrow. The old battery can now be removed by turning
the unit over and tapping gently. Unclip the connector from the battery. Fit a new battery
making sure that the wires are tucked out of the way. Slide the battery cover into place.
Battery type : PP3, 6R61, MN1604, 6LF22 or equivalent. We would suggest that batteries
are bought from a reputable shop with a reasonable turnover to ensure "fresh" stock. There
is little difference in the cost of running the Crescendo with either ordinary or alkaline
batteries. The alkaline type will last longer but cost more.
Deleted: ¶
Accessories and Spares
Crescendo 10/1 Plus
A full list of accessories and spares with prices is shown in our current product guide,
available on request. Please check the current price and quote both the description and part
number when ordering.
Part No.
330-001
330-007
330-100
330-009
Description
Standard Microphone with 4m(12ft) BLACK lead and Velcro pads
Standard Microphone with 4m(12ft) WHITE lead and Velcro pads
Short lead Microphone with 1m(3ft) BLACK lead
Communicator Microphone with NO lead, direct plug in.
353-090
353-092
353-024
353-025
Crescendo direct audio lead kit to replace microphone
Crescendo direct audio lead for SCART socket
Microphone extension lead 3m(10ft)
Microphone extension lead 5m(15ft)
330-044
Velcro pads kit, One hook type and three black loop type pads
To obtain this kit only, please send two second class stamps
310-111
302-016
301-007
Stethoscope headset complete
Stethoscope headset lead
Stethoscope headset foam pads (pack 10)
Personal Sound System
Owner’s Manual
Introduction
The Crescendo 10/1 Plus system is an easy to use amplifying system for use without a
hearing aid. With one simple volume control the user’s volume can be easily varied without
affecting others.
Your Crescendo 10/1 Plus is supplied ready to use with a battery, microphone, high
efficiency stethoscope headset and self-adhesive Velcro™ pads.
Deleted: ¶
¶
Product conforms to the provisions of the following European Union Directives :
Deleted: ¶
¶
• 89/336 & 92/31 Electro Magnetic Compatibility Directives
• 93/68 CE Marking Directive
Sarabec Limited 15 High Force Road Middlesbrough TS2 1RH
Telephone (01642) 247789 Fax (01642) 230827 Text (01642) 251310
is a mark of Sarabec Ltd.
© Sarabec Ltd 104-301.003 1298 Cres 10.doc
®
Deleted:
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement