English Theft-resistant Cage Identification Manual

English Theft-resistant Cage Identification Manual
D2 Turbo Theft-resistant cage
parts identification
TM
D2
Turbo
DOMESTIC
SLIDING GATE
OPERATOR
1. General description
The CENTURION D2 Turbo Theft-resistant Cage is designed to significantly reduce the risk of
an intruder gaining access to the operator and increases the resistance of the unit against theft.
Manufactured from 304 brushed stainless steel, it will not only enhance the security of your
entrance, but will add to the aesthetic appeal too.
It is important that the Theft-resistant Cage is properly fitted as per the instructions given and
that a suitable lock is fitted. Please note that a lock is not supplied in this kit. CENTURION
recommends using a discus-type lock.
Disclaimer: Centurion Systems (Pty) Ltd cannot be held liable under any circumstances for any
damage, loss or action that results from the D2 Turbo Theft-resistant Cage being forced open
or tampered with.
2. Product identification
1
2
3
4
FIGURE 1 D2 TURBO THEFT-RESISTANT CAGE IN OPEN (UNFOLDED) CONFIGURATION
1.
2.
10mm holes for discus type lock
Rear strap
3.
4.
page 1
Hinge pin
Front strap
3. Step-by-step installation instructions
1. Remove the D2 Turbo unit from the
height adjusters, and position the
Theft-resistant Cage on the retaining
studs.
2. Place the D2 Turbo unit back on top
of the Theft-resistant Cage and
position it on the retaining studs.
3. Replace the M10 washers and nuts on
the studs on the left hand side.
4. Replace the M10 washers and nuts on
the studs on the right hand side.
5. Reconnect the power and battery
6. Position the motor and pinion in
relation to the rack, ensuring it is
correctly aligned and at the correct
height. Re-fasten the nuts.
page 2
7. Return the cover to the operator and
clip into place. Return the manual
release thumbwheel to the ‘locked’
position
8. Fold the front strap of the Theftresistant Cage up and over the unit
so that the 10mm holes on the tabs
line up.
Lock the cover in place using the
camlock key supplied with the operator.
9. Place the discus type padlock (not
included in this kit) through the holes
to lock the Theft-resistant Cage
straps together.
0.07.A.0011_22072013
www.centsys.com
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement