JCD2010 Troubleshooting Guide
Radio will not turn ON
Try the reset button.
Check fuse.
Check +12V on battery wire to radio (YELLOW wire).
Check +12V on accessory wire to radio (RED wire).
Check Ground.
Radio turns ON, but no sound
Verify Volume¸ Fader/Balance¸ Mute controls are set correctly (see owners manual).
Try RESET button.
Verify proper speaker connections.
Check for shorts or opens on speaker wires.
CD does not load fully
Make sure unit has power and no other CD is currently inside.
Inspect ra dio’s chassis to verify shipping screw(s) have been removed.
CD does not play correctly
Check to make sure disc is inserted correctly.
Verify disc is free from dirt, scratches, etc.
Check with factory CDs.
Check factory original CDs for compatibility warnings (due to various copy-protection, multi-media content, etc).
Disc skips during playback – verify you have not exceeded 30 degrees mounting angle.
No AM or FM reception
Verify you are tuned to a valid station.
Check your antenna connection on rear of stereo.
Replace with another antenna.
No audio in AUX mode
Verify audio cable is connected securely to radio and source.
Test with different audio cable.
Verify volume level on source is turned all the way up.
B. Woods
Tech Services
02.06.13
JCD2010 Troubleshooting Guide Page 1 of 1