Ford Mustang Trunk Tool Kit Installation Instructions

Ford Mustang Trunk Tool Kit Installation Instructions
Ford Mustang Trunk Tool Kit
Application: 2005-09 Ford Mustang
Installation Instructions
Before installing your ROUSH Performance Product(s), read through the entire installation
procedure and check to make sure all items are present. Contact ROUSH Customer Service at
1-800-59-ROUSH, 9:00 AM to 5:00 PM weekdays, for any questions regarding fit or instructions
that are unclear to you.
Packaging List for the ROUSH Trunk Tool Kit # R08030006
Item
Trunk Tool Box
Part No.
R08030007
Quantity
1
Adapter Brackets
R08030008
2
Hardware Kit
R08030009
1
2
2
R08030025
1
Screws
Washers
Installation Instructions
1305-R08030025-AA
Page 1 of 6
1-800-59-ROUSH
Part No.
Item
Tool Kit Contents
R08030011
Screwdriver (multi-bit)
R08030012
Socket and Ratchet Set
R08030013
includes (4) sockets (1) ratchet
Flashlight
R08030014
Tire Pressure Gauge
R08030015
Combination Screwdriver
R08030016
Silver ROUSH Coin Medallion
SM01-5808-S
Tire Depth Gauge
R08030017
Slip Joint Pliers
R08030018
Needle Nose Pliers
R08030019
ROUSH Mechanics Gloves – pair
R08030020
Wrench - 8mm
R08030021
Wrench - 10mm
R08030022
Wrench - 13mm
R08030023
Wrench - 3/8"
R08030024
(Fits valve stem cap and antenna nut)
Quantity
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
Equipment and Supplies Required
3/16” Hex Driver
Suggested Materials
Masking Tape
1305-R08030025-AA
Page 2 of 6
1-800-59-ROUSH
LIMIT OF LIABILITY STATEMENT
The information contained in this publication was accurate and in effect at the time the
publication was approved for printing and is subject to change without notice or liability.
ROUSH Performance Products (RPP) reserves the right to revise the information presented
herein or to discontinue the production of parts described at any time.
SAFETY REQUIREMENTS
STOP! READ IMPORTANT SAFETY CAUTIONS AND WARNINGS BEFORE
PROCEEDING.
IMPORTANT SAFETY NOTICE
Appropriate disassembly, assembly methods and procedures are essential to ensure the
personal safety of the individual performing the kit installation. Improper installation due to the
failure to correctly follow these instructions could cause personal injury or death. Read each
step of the installation manual carefully before starting the actual installation.
1.
2.
3.
4.
5.
Always wear safety glasses for eye protection.
Place ignition switch in the OFF position.
Always apply the parking brake when working on a vehicle.
Block the front and rear tire surface to prevent unexpected vehicle movement.
If working without a lift, always consult vehicle manual for correct lifting
specifications.
6. Operate the engine only in well-ventilated areas to avoid exposure to carbon
monoxide.
7. Do not smoke or use flammable items near or around the fuel system.
8. Use chemicals and cleaners in well-ventilated areas.
9. Batteries produce explosive gases, which can cause personal injury. Therefore, do
not allow flames, sparks or flammable substances to come near the battery.
10. Keeps hands and any other objects away from the radiator fan blades.
11. Keep yourself and your clothing away from moving parts when the engine is
running.
12. Do not wear loose clothing or jewelry that can get caught in rotating parts or scratch
surface finishes.
13. Allow the engine, cooling system, brakes and exhaust to cool before working on a
vehicle.
WORK SAFELY!
Perform this installation on a good clean level surface for maximum safety and with the
engine turned off.
1305-R08030025-AA
Page 3 of 6
1-800-59-ROUSH
Installation
1. Remove the two wire harness retaining clips on the passenger side of the decklid and
pull the harness down so that it can fit into the recessed portion of the inner structure.
(Refer to Figure A)
Hint: Masking tape can be used to hold the harness in place. The 2 harness retainers can
be cut off as they are not used with the toolkit.
Figure A
2. Insert the adapter brackets into each of the inner most triangular shaped cutouts in the
inner structure by placing the side with the wider shoulder against the lid and sliding the
bracket over so that the shoulders are between the inner and outer shells. (Refer to
Figure B) The shouldered sides should be perfectly flush with the edges of the cut-out.
Figure B
1305-R08030025-AA
Page 4 of 6
1-800-59-ROUSH
3. Remove the ROUSH Mechanics gloves from the toolkit. Raise the ROUSH Tool box to
the adapter brackets and fasten it to the brackets using the screws and washers
supplied in the Hardware Kit. (Refer to Figure C)
Figure C
Congratulations!!! You have completed the installation of the ROUSH Performance Products,
Ford Mustang Trunk Tool Kit. It is recommended that you save all parts removed from your
vehicle during the installation of this kit.
1305-R08030025-AA
Page 5 of 6
1-800-59-ROUSH
WARRANTY
All retail parts carry a 90-day warranty from the date of purchase. This warranty covers defects
in materials or workmanship, and does not include (i) normal wear and tear, environmental
conditions, improper installation; (ii) road hazards, misuse, abuse, neglect, accidents, collision,
fire, theft, freezing, vandalism, riot, explosion, or objects striking the vehicle; (iii) misusing the
vehicle, such as driving over curbs, overloading, racing, or using the vehicle as a stationary
power source; (iv) altering, disassembling or modifying the parts; (v) defects caused or induced
by failures, breakdowns, or damage by other parts, components or the vehicle; (vi) subjecting
the parts to excessive moisture or water or any motor vehicle fluids (e.g.: oil, anti-freeze,
battery acid, brake fluid, etc.); (vii) acts of God, natural disasters and other similar causes
beyond the reasonable control of ROUSH; or (viii) application of chemicals that affect the parts.
This Limited Warranty does not cover surface deterioration of paint, trim, and appearance items
that result from use and/or exposure to the elements, such as stone chips, scratches, bird
droppings, lightning, hail, windstorm, dings, dents, earthquake, road salt, tree sap, water or
flood.
ROUSH SHALL NOT BE LIABLE TO REIMBURSE CUSTOMER/DEALER FOR INCIDENTAL OR
CONSEQUENTIAL DAMAGES RESULTING FROM THE INSTALLATION OR USE OF ANY PRODUCT
SOLD THROUGH THIS CATALOG OR ARISING OUT OF ANY BREACH OF WARRANTY. EXCEPT
AS MAY BE STATED IN THIS CATALOG, ROUSH DISCLAIMS ALL EXPRESS AND IMPLIED
WARRANTIES, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A
PARTICULAR PURPOSE. IN NO EVENT SHALL ROUSH’S LIABILITY EXCEED THE PRICE PAID BY
CUSTOMER/DEALER FOR PRODUCTS SOLD REGARDLESS IF ROUSH HAS BEEN ADVISED IN
ADVANCE OF ANY POTENTIAL PROBLEM OR IF A CLAIM IS BASED ON CONTRACT, TORT,
STRICT LIABILITY, PRODUCT LIABILITY OR OTHERWISE. SOME STATES DO NOT ALLOW THE
EXCLUSION OR LIMITATION OF IMPLIED WARRANTIES OR THEIR DURATION, OR LIABILITY
FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES, SO THE ABOVE EXCLUSIONS OR
LIMITATIONS MAY NOT APPLY.
1305-R08030025-AA
Page 6 of 6
1-800-59-ROUSH
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement