Teradek_Clip-Encoder_Manual

Teradek_Clip-Encoder_Manual
A: Wireless Antenna
B: Power Input
C: Micro HDMI Video Input
D: Mode Button
E: Auxiliary Connector
F: Stream Status Indicator
G: Client Status Indicator
H: Access Point Status Indicator
I: Reset Button
J: WiFi Status Indicator
K: Encoder Status Indicator
L: Video Status Indicator
A
B
C
D
E
LED Description Off F G H
I
Red/Yellow Stream
Not streaming Client not responding
Client
No clients
N/A
AP (Access Point) N/A
Infrastructure Mode
WiFi Not configured 2.4GHz
Encoder Not encoding Restarting/no host
Video
No video
Video not supported
J K L
Blue
Streaming
AP Mode
• Solid: Client(s)
Connected
Infrastructure mode
• Blinking: Connecting
• Solid: Connected
AP Mode
5GHz
Ready/Encoding
Video sync
Button Operation
Mode Button
• Hold for 1−2 seconds: Switches stream destination (when multiple
clients are connected).
• Hold for 6−8 seconds: Toggles between AP mode and Infrastructure
mode (if configured).
Reset Button
• Hold for 5 seconds: factory reset.
1
GETTING STARTED
1
iOS users − download the
TeraClip app.
3
Connect iPad to Clip’s network.
(WiFi SSID − CLIP−xxxx)
2
Plug power and video into
Clip. Attach antennas.
4
Open the TeraClip app.
2
IPAD APP
F
G H
A
I
B
J
C
K
D
E
A: Device Information
B: Video Input Status
C: Encoder Information
D: WiFi Network Information
E: Player Status
F: Browse Devices
G: Controls
H: Settings
I: Encoder Settings
J: Player Controls
K: Stop Watch/Timer
A:Displays Clip’s device name, serial number and IP address.
B: Displays input video resolution.
C: Displays current video quality and delay.
D: Displays the SSID of connected WiFi network.
E: Displays video stream bitrate and the load on the player.
F: Browse for Clip devices.
G: Viewer Control Panel settings.
H: Launch Clip’s full configuration menu.
I: Manually change the video quality and buffer for lower delay or
smoother video.
J: Switch Feed: Requests Clip to send the video stream to your iPad.
Orientation: Flips the video 180°.
Snapshot: Saves a snapshot of the video in the device’s album.
K: Touch "start" to count from zero, or touch "set" to set the countdown
timer. Use this to keep track of flight times, shot length, battery life, etc.
NEED MORE HELP?
1. Support forum: http://support.teradek.com → Contains tips, information
and all the latest firmware & software updates.
2. Training videos: http://www.teradek.com/training
TERADEK SUPPORT STAFF: [email protected] or call 888−941−2111 ext2
(Mon−Fri 9am to 6pm PST)
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement