Crestron | TST-600-DSW-PMK | Installation Guide: TST-600-DSW-PMK

Crestron TST-600-DSW-PMK
Pre-Construction Wall Mount Kit
for TST-600-DSW
Installation Guide
Crestron TST-600-DSW-PMK
Pre-Construction Wall Mount Kit
Contents
Pre-Construction Wall Mount Kit for TST-600-DSW: TST-600-DSW-PMK
1
Description................................................................................................................................. 1
Setup .......................................................................................................................................... 4
Supplied Hardware ...................................................................................................... 4
Mounting ..................................................................................................................... 4
Installation ................................................................................................................... 7
Other Mounting Option Accessories ........................................................................... 7
Resources ................................................................................................................................... 8
Reference Documents .................................................................................................. 8
Further Inquiries .......................................................................................................... 8
Future Updates ............................................................................................................ 8
.
Product warranty can be found at www.crestron.com/warranty.
The specific patents that cover Crestron products are listed at patents.crestron.com.
Crestron and the Crestron logo are either trademarks or registered trademarks of Crestron Electronics, Inc. in the
United States and/or other countries. Other trademarks, registered trademarks, and trade names may be used in this
document to refer to either the entities claiming the marks and names or their products. Crestron disclaims any
proprietary interest in the marks and names of others. Crestron is not responsible for errors in typography or
photography.
This document was written by the Technical Publications department at Crestron.
©2014 Crestron Electronics, Inc.
Crestron TST-600-DSW-PMK
Pre-Construction Wall Mount Kit
Pre-Construction Wall Mount Kit
for TST-600-DSW:
TST-600-DSW-PMK
Description
The TST-600-DSW-PMK provides a simple solution for installing the Crestron®
TST-600-DSW Wall Mount Docking Station and the TST-600-WALL and
TST-602-WALL Wall Mount Wireless Touch Screens in a typical framed wall.
Designed for pre-construction applications, the TST-600-DSW-PMK permits
fastening to a stud of a framed wall prior to installation of drywall. A blank cover
plate is included to provide a temporary cover for the opening during construction.
For custom placement of the TST-600-DSW without a stud, use the
TST-600-DSW-WMKT or TST-600-DSW-WMKM.
The TST-600-DSW-PMK includes a 12-inch long, 18 AWG jumper wire to secure
docking station cabling prior to drywall installation and to avoid damaging the cables
when the opening is routed.
NOTE: If mounting in a material other than drywall (for example, wood lectern,
concrete or rock) use the cutout template, available in the post-construction kit
TST-600-DSW-WMKM or TST-600-DSW-WMKT. For concrete and rock
installations, allow for proper ventilation before mounting the TST-600-DSW.
NOTE: This mounting kit is to be used only with the TST-600-DSW Wall Mount
Docking Station.
Installation Guide – DOC. 7453B
Pre-Construction Wall Mount Kit for TST-600-DSW: TST-600-DSW-PMK • 1
Pre-Construction Wall Mount Kit
Crestron TST-600-DSW-PMK
The dimensions of the TST-600-DSW-PMK are shown in the following illustrations.
TST-600-DSW-PMK Overall Dimensions (1 of 2)
0.56 in
(15 mm)
11.90 in
(303 mm)
8.00 in
(204 mm)
0.06 in
(2 mm)
#06-32 Tapped Hole in Each Corner
8.82 in
(225 mm)
6.35 in
(162 mm)
Secure 18 AWG Jumper Wire
in Notch to Hang Cables
Away From Cutting Tools
For Drywall Screws (Not Included)
For Drywall Nails (Not Included)
2 • Pre-Construction Wall Mount Kit for TST-600-DSW: TST-600-DSW-PMK
Installation Guide – DOC. 7453B
Crestron TST-600-DSW-PMK
Pre-Construction Wall Mount Kit
TST-600-DSW-PMK Overall Dimensions (2 of 2)
8 15/16 in
(226 mm) 7 3/4 in
(196 mm)
1/2 in
(13 mm)
6 3/4 in
(171 mm)
6 in
(152 mm)
1/2 in
(13 mm)
1/8 in
(4 mm)
3/16 in
(5 mm)
5 in
(127 mm)
6 3/16 in
(158 mm)
6 1/8 in
(156 mm)
5 13/16 in
(148 mm)
TST-600-DSW-PMK Overall Dimensions (Cover Plate)
5.85 in
(149 mm)
4.16 in
(106 mm)
0.02 in
(1 mm)
Installation Guide – DOC. 7453B
Pre-Construction Wall Mount Kit for TST-600-DSW: TST-600-DSW-PMK • 3
Pre-Construction Wall Mount Kit
Crestron TST-600-DSW-PMK
Setup
Supplied Hardware
The hardware supplied with the TST-600-DSW-PMK is listed in the following table.
Supplied Hardware for the TST-600-DSW-PMK
DESCRIPTION
PART NUMBER
QUANTITY
Metal, Plate, Pre-Construction
4507464
1
Metal, Plate, Blank, Cover
2022825
1
Screw, #06-32 x 1-1/2”, Pan, Phil
2007254
4
Wire, Jumper, 12”, 18 AWG, Black
2007838
1
Mounting
The TST-600-DSW-PMK consists of a single metal plate, which fastens to a stud of
a framed wall prior to hanging drywall. Standard drywall nails or screws to attach the
TST-600-DSW-PMK are not included.
The plate is designed to provide the necessary support for the TST-600-DSW and
can mount on the right or left side of a stud. Confirm that the TST-600-DSW-PMK
is level before applying drywall.
4 • Pre-Construction Wall Mount Kit for TST-600-DSW: TST-600-DSW-PMK
Installation Guide – DOC. 7453B
Crestron TST-600-DSW-PMK
Pre-Construction Wall Mount Kit
Mounting the TST-600-DSW-PMK
TST-600-DSW-PMK
(4507464)
NOTE: Ensure plate
is level when mounted
CAUTION: Allow an air gap of at least 12 inches (305 mm) in the wall cavity
above and below the TST-600-DSW for heat dissipation.
After drywall is positioned, a rectangular opening must be made. Position the
opening to expose the #06-32 tapped holes near the four corners of the opening in the
plate.
NOTE: Cut the drywall along the inside edge of the front of the mounting plate.
The labels on the front of the mounting plate indicate the perimeter of the opening
that should be cut. Refer to NOTE in the illustration above.
Installation Guide – DOC. 7453B
Pre-Construction Wall Mount Kit for TST-600-DSW: TST-600-DSW-PMK • 5
Pre-Construction Wall Mount Kit
Crestron TST-600-DSW-PMK
Mounted View with Cover Plate
NOTE: Be sure to leave
the four tapped holes
on the front of the plate
exposed to accept the
mounting screws.
NOTE: Mounting plate is to be
covered with drywall and then
the cutout made around the
inside of the opening.
Screws (4)
#06-32 x 1 1/2” Pan,
(2007254)
Cover Plate (2022825)
to cover cutout in drywall
before TST-600-DSW is
installed (may be required
by local building codes)
NOTE: The four tapped holes on the front of the mounting plate must be exposed to
accept the TST-600-DSW mounting screws. These holes are found along the top and
bottom of the opening made by cutting out the drywall. Refer to NOTEs in the
illustration above.
6 • Pre-Construction Wall Mount Kit for TST-600-DSW: TST-600-DSW-PMK
Installation Guide – DOC. 7453B
Crestron TST-600-DSW-PMK
Pre-Construction Wall Mount Kit
Installation
Complete the installation by either installing the TST-600-DSW, leaving the hole
open (if permitted by local building codes) or installing the optional cover plate with
the included #06-32 x 1-1/2” screws. If the TST-600-DSW is to be installed, refer to
the latest version of the TST-600-DSW Operations & Installation Guide (Doc. 7434)
for installation instructions. The document is available at
www.crestron.com/manuals. Refer also to the following comprehensive illustration.
TST-600-DSW Mounting (Exploded View)
TST-600-DSW-PMK
TST-600-DSW
Drywall
Screws (4)
#06-32 x 1 1/2” Pan,
(2007254)
Other Mounting Option Accessories
If too much of the mounting plate is exposed after the drywall is cut, the area may
need to be patched. Crestron provides the following accessories:
•
TST-600-DSW-TMK (Doc. 7456): for smaller repairs and to provide a
smooth edge at the opening. This option provides a finished appearance and
is preferred when wallpaper is hung.
•
TST-600-DSW-MMK (Doc. 7457): for larger repairs and to fill in larger
irregularities around the opening (requires plastering).
The manuals for the TST-600-DSW-TMK and TST-600-DSW-MMK are available
at www.crestron.com/manuals.
Installation Guide – DOC. 7453B
Pre-Construction Wall Mount Kit for TST-600-DSW: TST-600-DSW-PMK • 7
Pre-Construction Wall Mount Kit
Crestron TST-600-DSW-PMK
Resources
Reference Documents
All documents mentioned in this guide are available at www.crestron.com/manuals.
List of Related Reference Documents
DOCUMENT TITLE
TST-600-DSW Wall Mount Docking Station for TST-602
TST-600-DSW-MMK & TST-600-DSW-WMKM Mud Mount Kits for TST-600-DSW
TST-600-DSW-TTK & TST-600-DSW-WMKT Trim Ring Kits for TST-600-DSW
Further Inquiries
To locate specific information or resolve questions after reviewing this guide,
contact Crestron's True Blue Support at 1-888-CRESTRON [1-888-273-7876] or, for
assistance within a particular geographic region, refer to the listing of Crestron
worldwide offices at www.crestron.com/offices.
To post a question about Crestron products, log onto Crestron’s Online Help at
www.crestron.com/onlinehelp. First-time users must establish a user account to fully
benefit from all available features.
Future Updates
As Crestron improves functions, adds new features, and extends the capabilities of
the TST-600-DSW-PMK, additional information may be made available as manual
updates. These updates are solely electronic and serve as intermediary supplements
prior to the release of a complete technical documentation revision.
Check the Crestron website periodically for manual update availability and its
relevance. Updates are identified as an “Addendum” in the Download column.
8 • Pre-Construction Wall Mount Kit for TST-600-DSW: TST-600-DSW-PMK
Installation Guide – DOC. 7453B
Crestron TST-600-DSW-PMK
Pre-Construction Wall Mount Kit
This page is intentionally left blank.
Installation Guide – DOC. 7453B
Pre-Construction Wall Mount Kit for TST-600-DSW: TST-600-DSW-PMK • 9
Crestron Electronics, Inc.
15 Volvo Drive Rockleigh, NJ 07647
Tel: 888.CRESTRON
Fax: 201.767.7576
www.crestron.com
Installation Guide – DOC. 7453B
(2035127)
12.14
Specifications subject to
change without notice.
Download PDF