BUNN� 5-Hoppers Fresh Mix Dispenser

BUNN� 5-Hoppers Fresh Mix Dispenser
INTERNATIONAL
ITEM#
Fresh Mix Dispenser
with 5 Hoppers
PROJECT
DATE
Features
Fresh Mix Dispensers with 5 Hoppers
• Capacity: Five, 4-pound hoppers
• Large, lighted front graphics for merchandising
• 6.4 gallon (24.2 litres) hot water tank to meet peak serving times
• Cup clearance at 7” (17.8 cm) to accommodate common cup sizes
• Electrical and plumbing components easily accessible through front and top
• Variable speed motors allow control of product consistency in mixing
chamber (.75 to 6.6 grams of powder per second)
• High speed, heavy-duty whipper for complete product mixing
• Front of machine access to tank drain for easy service
• Key lock on the door prevents tampering
FMD-5
Dimensions: 29.3”H x 18.6”W x 21.2”D
(74.4 cm H x 47.2 cm W x 53.8 cm D)
For current specification sheets and other information, go to www.bunn.com.
International models may vary in appearance.
Related Products
Easy Clear® EQ-11-TL
Product No. : 30344.1001
Easy Clear® ED-11-TL
Product No. : 30244.1001
Single hopper
model shown.
Features deluxe whipper chambers:
1. Robust whipper to ensure full flavor yield.
2. Specially designed self cleaning mixing
chamber.
Whipper Chamber
Receptacle
O-ring
Steam Collector
Mixing Chamber
3. Exhaust fan to siphon off moisture that
can cause powder buildup.
4. Hot water dispense for easy clean-out.
5. Quick disconnecting parts for thorough
sanitizing.
ON
TT
E BU
AS
LE
RE
EN
WH
P IS
CU
2/3
LL
FU
E
AC
PL RE
P HE
CU
Frother
Whipper
Chamber
Patents Apply
Dispense
Tip
12/06
D4.1
Dimensions & Specifications
Model
Product #
Volts
Amps
FMDA-5
34900.0010
230
15
Tank Heater
Watts
3500
Total
Watts
3600
Capacity
Shipping
Cord
Weight
Attached
4.2 gal/hr.** 118 lbs.
(15.9 L/hr.) (53.5 kg)
Agency
Yes
**Based on incoming water temperature of 50oF /10˚C
Electrical: Model requires 2-wires plus ground service rated 220-240V, single phase, 50/60 hz.
Plumbing: 20-100 psi (138-690 kPa) from a 3⁄8” or larger supply line. A shut-off valve should be installed in the line
before the unit. Install a regulator in line when pressure is greater than 90 psi to reduce it to 50 psi. Supplied
with 3⁄8” male flare fitting.
BUNN Corporation - 1400 Stevenson Drive Springfield, Illinois 62703 • USA • +1-217-529-6601 • Fax +1-217-529-2827 • www.bunn.com
BUNN® practices continuous product research and improvement. We reserve the right to change specifications and product design without notice. Such
revisions do not entitle the buyer to corresponding changes, improvements, additions or replacements for previously purchased equipment.
All dimensions shown in centimeters.
Bunn Corporation owns all copyrights relating to materials in this publication. Please contact Bunn Corporation to request permission to reproduce any portion of this publication.
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement