User manual | WIRING INSTRUCTIONS BULLETIN 58-01-5380 1/2" HAMMER-DRILL

WIRING INSTRUCTIONS
TITLE
1/2" HAMMER-DRILL
BULLETIN
MILWAUKEE ELECTRIC TOOL CORP. 13135 WEST LISBON RD. BROOKFIELD, WIS.
DATE
58-01-5380
Oct. 2007
NOTE:
*As an aid to reassembly, take note of the wire routings and position of the wires in the wire guides and wire guides traps prior to dismantling the tool.
*With the switch installed and wire routing complete, make sure that wires #3, #6, #7 and #8 are pulled away from the heat sink as much as possible.
1
*Watch for pinched wires when placing the handle cover back over the housing assembly.
2
3
REAR VIEW
SWITCH
4
5
7
SWITCH
6
8
BOTTOM OF SWITCH
Carbon Brush Copper Shunt Wire Install to the lower/inner terminal
of the Brush Holder
9
10
YELLOW (6) TO FIELD
YELLOW (8) TO CORD
BLACK (7) TO CORD
BLACK (3) TO FIELD
Switch Leadwire (#2 or #5) Install to upper/outer terminal
WIRING SPECIFICATIONS
Wire
No.
Wire
Color
Orgin of
Gauge
Length
Terminals, Connectors and 1 or 2 End Wire Preparation
1
Red
--------
--------
23-94-6710 Leadwire Assembly
2
Red
--------
--------
23-94-6710 Leadwire Assembly
3
Black
--------
--------
23-94-6735 Leadwire Assembly
4
Gray
--------
--------
23-94-6715 Leadwire Assembly
5
Purple
--------
--------
23-94-6720 Leadwire Assembly
6
Yellow
--------
--------
23-94-6730 Leadwire Assembly
7
Black
--------
--------
23-94-6740 Leadwire Assembly
8
Yellow
--------
--------
23-94-6745 Leadwire Assembly
9
Black
--------
--------
Component of Cord Set
10
White
--------
--------
Component of Cord Set
BULK LEAD WIRE - BULLETIN 58-01-0003
NOTE:
All leads must be held to ± 1/16".
All lead lengths are before stripping.
TERMINAL DESCRIPTION
Code
Part No.
Qnty.
CONNECTOR DESCRIPTION
Drwg.2

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project