DA-JB2200 INSTALLATION MANUAL
This manual is intended for users of the DA-JB2200 ceiling mounting bracket. It includes instructions for mounting the DA-JB2200 ceiling mounting bracket to a ceiling.
• This bracket is intended to be used with a specific model of camera.
Do not use it with other models of cameras except for those approved by the dealer or distributor.
• This installation should be performed by a qualified service personnel in conformance to all local codes.
• You may need to reinforce the ceiling. If the ceiling is not strong enough to support the camera, the camera may fall.
• Do not use this product for other purposes.
Mounting
Mount the bracket to the ceiling as follows:
1 Insert cables from external devices, network and power adapter to the sponge and bracket. If you have a PT 1/2 inch pipe, remove the PT 1/2 inch cap and make the cables go through the pipe. Assemble the removed PT 1/2 inch cap to the bracket's ceiling hole. Ask your dealer or distributor for details about connecting a pipe.
2 Mount bracket to the ceiling by using the provided anchors, rubbers, and screws.
Make sure that a rubber is attached between bracket and a screw.
Connect your camera to the bracket as follows:
3 Screw the camera body onto bracket.
4 Screw the camera dome cover onto the camera body.
5 Turn on power.
Bracket
Safety wire
Camera body
PT 1/2 inch CAP
Bracket
Rubber
Camera body
Safety wire
Dome cover
Ceiling Hole
Dimensions
3 - 120
°
3 - M4 TAP
Ø 142 (5.59)
Ø 155 (6.10)
NPT 3/4 inch
33.3 (1.31)
Unit: mm (inch)
IDIS Co., Ltd.
For more information, please visit www.idisglobal.com
Ver.1.0
