Knuckle Bolt Set 5/16” Upper or Lower Installation Tools Compatible with Power-Pole XL 8’ 2008 & Earlier Power-Pole 6’ 2008 & Earlier Power-Pole Pro Series 6’ or 8’ 2009 & Later Power-Pole Sportsman Series 6’ or 8’ 2009 & Later Power-Pole Signature Series 4’, 6’, & 8’ 2010 ½” Socket with Ratchet ½” Wrench Drill 3/8” Steel Drill Bit A. E. B . Hardware A. Qty (1) 5/16 x 3.5” Knuckle bolt B. Qty (2) small washers C.Qty (2) small black bushings D.Qty (4) large black bushings E. Qty (1) low-profile mounting nut D. C. Note: If existing Power-Pole Knuckle has a ¼” bolt you will need to drill it out with 3/8” steel drill bit. Installation Instructions: Step 1Remove old bolt and bushings with installation tools. Step 2 Insert large black bushings D with small flange facing hole on the outside of the Knuckle and inside of the U-channel. Step 3 Put washer B on bolt A. Next put small black bushing C on the bolt A with the flat side pointing towards washer B. Step 4 Install knuckle in-between U-channels as pictured below with flat side of bushings D touching and aligning the hole. Step 5 Insert the dressed bolt A through the U-channel and Knuckle. Step 6 Place small bushing C onto bolt A with small flange facing towards U-channel hole followed by washer B. Step 7 Finish by threading nut E on and tighten to 48 inch pounds / 4 foot pounds of torque. A. B. C. C. Upper B. E. Knuckle Joint U-channel D. D. Knuckle Joint D. D. Lower A. B. U-channel C. D. D. D. D. C. B. E. Everflex Spike Rev. A-10.21.10 Page 1
* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project
advertisement
© 2021