Methven Koha Satinjet Slide Rail/Handset and Hose shower Installation guide

CLEANING
Water contains lime which remains on the
surface after the water has evaporated. These
lime deposits can be prevented from forming by
wiping immediately after use.
To clean the chrome-plated surface use a soft
cloth, soap and warm water. Never use cleaning
agents that contain a corrosive acid or a scouring
additive.
Do not use any
sharp objects to
clean nozzles
Notes:
●● After installation all connections must be
checked for leaks.
●● All installations must be carried out in
compliance with relevant water regulations.
NOTE: Removal of the flow restrictor with pliers may
be necessary to optimise flow performance in low
or unequal pressure systems only. Flow restrictor is
lodged firmly in the end of the handset.
Methven warrants this product against manufacturing defects and that it is suitable for use
under the operating conditions specified in this instruction sheet.
For your warranty please refer to www.methven.com or call Customer Service
436650
Australia
1300 638 483
TECHNICAL SPECIFICATIONS
Operating Pressure:
Min 35 kPa, Max 500 kPa.
Recommended installation of a pressure
limiting valve if supply exceeds 500kPa.
Operating Temperature:
Max 70°C.
NB: New Zealand Building Code Clause G12 Water Supplies specifies all outlets used
primarily for personal hygiene shall deliver
water at a safe temperature.
Inlet Connections: All ½" BSP.
Clean filter washer
periodicallly
New Zealand
0800 804 222
KOHA SATINJET SLIDE RAIL/
HANDSET AND HOSE
INSTALLATION GUIDE
USA
1800 975 5409
UK
0800 195 1602
Issue A
1.
2.
3.
4.
grub screw topside
Koha Handset
Slider
Hose
Rail
Shelf
1850mm (recommended)
NOTE: ENSURE
PROTECTION
PADS ARE USED
BETWEEN WALL
BOSSES AND TILES
Internal Mounting Bracket
810-945mm
Wall Boss Housing
Fit the internal mounting
brackets by locating in slot
and rotating 90° as shown.
Attach the shelf to the
rail.
grub screw underside
Elbow
Screw
Grub Screw
Once located tighten the
screws finger-tight.
Secure the wall boss housings in
desired position with 4 screws.
Check the mounts are vertical.
Ensure the grub screws are
located as shown.
Floor
5.
6.
Match the mountings
up to the wall bosses
and push into place.
Slide the rail up and
down if required to
centralise the rail on
the brackets
7.
8.
NOTE: TO LOOSEN SLIDERS
GRIP ON RAIL ROTATE SIDE
PIECE ANTI-CLOCKWISE.
ROTATE CLOCKWISE TO
TIGHTEN
Once satisfied that
the rail is centralised
remove the rail and
tighten the tensioning
screws until they lock.
Relocate the rail
onto wall bosses and
tighten grub screws
top and bottom.
Fit end caps top
and bottom. Ensure
drainage holes are
at back