MyBinding Xyron Personal Cutting Sytem User guide

Below you will find brief information for Personal Cutting System . The Personal Cutting System is designed for cutting standard sized paper with a wide variety of shapes. The system includes a cutting mat, loading tray, and a blade. Use the Design Book and the LCD screen to choose your favorite shape, then press the cut button to automatically cut your paper. It is a user-friendly system that can be used for paper crafts, scrapbooking, and other creative projects.

PDF Download
Document
Xyron Personal Cutting System User Manual | Manualzz

Advertisement

Advertisement

Advertisement

Key features

  • Automatic shape cutting
  • Easy to use interface
  • Design Book for shape selection
  • Cutting mat and blade
  • Adjustable cutting pressure
  • Multiple cutting materials supported

Frequently asked questions

If the machine is used for standard non-woven papers the blade should last for over 500 cuts.

If the machine is used to cut standard non-fibrous paper the cutting mat should last for over 250 cuts. The cutting mat can be removed and rotated to maximize the “stickiness” left on other portions of the mat.

The cut mat may be dirty. Try the following: Clean fibers by applying standard tape and lifting the tape off quickly. The paper may be wax coated, have a lot of soft fibers or have some other coating on it. Turn the paper upside down to help adhere to the cut mat. Replace the cut mat.

The Design Book may not be installed properly. Try the following: The Design Book has small tabs that fit into the book tray sensors (see fig 4.3) Locate the word “push” on the book tabs and push down toward the tray to engage the sensor. Turn the machine off, then on again. The Design Book may not have been recognized the first time. The pages may not be overlaying the buttons correctly due to an improper orientation of the book. Remove the Design Book from the Book Dock and re-install. There may be debris in the book tray connector. Use a commercial air can to clean the connector. DO NOT use any metal to retrieve debris as this will void the product warranty.

The cutting blade may be loose. Open the lid, firmly press the blade into place and tighten the screw on the right side of the orange blade holder. The paper may be too thick. Paper should not exceed 80-pound cover weight or .010 inches in thickness. The cutting mat may need to be replaced. If the cutting mat has a lot of wear this can cause the blade to cut inconsistently. Replace the cutting mat. The cutting blade could be dull. Change the blade. There may be adhesive or paper shards on the blade. Remove the blade, use the included Shape Removal Tool to pull off any visible paper, and wipe carefully with Isopropyl Alcohol.
Preparing document for printing…
0%