Stanley EPT-5 power transfer Installation instructions

Below you will find brief information for power transfer EPT-5. The EPT-5 is a power transfer device for use with doors and frames. It is designed for door openings less than 120 inches wide. The EPT-5 accepts jacketed cable up to 5/16 inches in diameter. The device is installed between the top and middle hinge reinforcement. The frame preparation requires a 10.25 inch long by 1 inch wide by 0.75 inch deep recess to be cut out.

PDF Download
Document
Power Transfer EPT-5 Installation Instructions | Manualzz

Advertisement

Advertisement

Advertisement

Key features

  • accepts jacketed cable up to 5/16 inches in diameter
  • designed for door openings less than 120 inches wide
  • installed between the top and middle hinge reinforcement
  • frame preparation requires a 10.25 inch long by 1 inch wide by 0.75 inch deep recess to be cut out

Frequently asked questions

The EPT-5 is intended for door openings less than 120 inches wide.

The EPT-5 accepts jacketed cable up to 5/16 inches in diameter.

The recommended position is between the top and middle hinge reinforcement.

The EPT-5 is compatible with wood and metal doors and frames.
Preparing document for printing…
0%