SPA400 Quickinstall Guide
1
Before You Begin
IMPORTANT:The SPA400 can only be used with the SPA9000. After connecting
the SPA400 as shown below, complete the configuration by using the
SPA9000’s Setup Wizard. For advanced configuration options refer to the
SPA400 section of the SPA9000 Administration Guide.
.
The SPA400 is an integrated part of the Linksys Voice System (LVS). The
SPA400 provides connectivity to the PSTN network and has an
integrated voice mail application available on the same platform.
This guide displays how to connect the SPA400 to the SPA9000. For
detailed system configuration steps, including setting up the voice
mail application, use the SPA9000 Setup Wizard (downloadable from
www.linksys.com) or refer to the SPA400 section of the SPA9000
Administration Guide.
2
A
B
C
D
Package Contents
•
•
•
•
•
•
Internet Telephony Gateway with 4 FXO Ports
Power Adapter
USB 1.1 Voice Mail Module
RJ-45 Ethernet Cable
4 -RJ11 Telephone Cables
Quick Installation
Connecting the SPA400
Connect the included
ethernet network cable
from the ethernet port on
the SPA400 to the ethernet port on the multi-port
switch.
Plug one end of a supplied RJ11 telephone
cable into one of the line
ports on the SPA400 and
the other end into the
RJ11 wall outlet.
D
Connect the included
power adapter to the
power port on the SPA400
and then plug the power
adapter into an electrical
outlet.
For additional information or troubleshooting
help go to the Linksys website. You can also
call or email for further support.
Website
http://www.linksys.com
http://www.linksys.com/support
E-mail Support
support@linksys.com
24-hour Technical Support
800-326-7114
(toll-free from US or Canada)
FTP Site
ftp://ftp.linksys.com
Sales Information
800-546-5797 (800-LINKSYS)
Linksys is a registered trademark or trademark of
Cisco Systems, Inc. and/or its affiliates in the U.S.
and certain other countries. Copyright © 2006
Cisco Systems, Inc. All rights reserved.
with 4 FXO Ports
Quick Installation
Voice
SPA400-QI-60503NC DF
No.
ModelModel
No. SPA400
B
Plug in the included USB
1.1 voice mail module
into the USB port.
The SPA400 connection is complete. After completing the
SPA9000 setup, you can use the
SPA9000 Setup Wizard or refer to
the SPA400 section of the SPA9000
Administration Guide for
advanced configuration options.
IP Telephony System
C A
Linksys Voice System Overview
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising