Bard QPBX42-10 -4, -V, -X, QPBX48-10 -4, -V, -X Top Fill Installation instructions

TOP FILL
INSTALLATION INSTRUCTIONS
QPBX42-10-4QPBX48-10-4
Bard Manufacturing Company, Inc. QPBX42-10-VQPBX48-10-V
Bryan, Ohio 43506
QPBX42-10-XQPBX48-10-X
APPLICATION
INSTALLATION INSTRUCTION
The Top Fill QPBX42-10 is to be used in conjunction
with QPB42 and QPBS42.
After the Plenum Box has been properly attached to
the QTec unit, place the side angles against the side
of the plenum and slide it up to the ceiling. Make
sure the angles are centered side to side. Mark
the holes to be drilled. Drill an 1/8" dia. hole in the
center of each mark. Reposition the angles and
attach with screws provided.
The QPBX42-10 will provide enclosure from the top
of the QPB42 or QPBS42 to 10'2" ceiling when used
with QH/QA units, and 10'5" when used with QWS
units.
The Top Fill QPBX48-10 is to be used in conjunction
with QPB48 and QPBS48.
The QPBX48-10 will provide enclosure from the top
of the QPB48 or QPBS48 to 10'2" ceiling when used
with QH/QA units, and 10'5" when used with QWS
units.
Place the front angle against the front of the plenum
box and slide it up to the ceiling. Make sure the
angle is centered sided to side. Mark the holes to
be drilled. Drill an 1/8" dia. hole in the center of the
marks. Reposition the angle and attach with the
screws provided.
Some trimming to fit around grille opening may be
required. Grille flanges cover trimmed area.
SIDE ANGLE
PLENUM BOX
OR
CABINET EXTENSION
SIDE ANGLE
FRONT ANGLE
MAY 23, 2013
7960-442C
Page
1 of 1
">