1XGTPKIJV"%JCTIGT"HQT"##1###1;8"0K/%F"QT"0K//*"$CVVGTKGU
23-437
OWNER’S MANUAL — Please read before using this equipment.
#"+/2146#06"#
If an icon appears at the end of a paragraph,
go to the box on that page with the
corresponding icon for pertinent information.
Rý— Warning
. — Caution
# — Important
° — Hint
± — Note
Thank you for purchasing the RadioShack
Overnight Charger for AA/AAA/9V Ni-Cd or
Ni-MH Batteries. Your charger is designed
to charge two or four AA or AAA batteries, or
one 9V battery.
Its features include:
Two Charging Indicators — FRONT or
REAR lights when charging batteries in the
front or rear charging bay and turns off when
charging is complete.
Reverse Polarity Protection — protects
the charger and batteries against damage
from incorrectly installed batteries.
Your charger is ETL listed to UL standards.
12'4#6+10
%*#4)+0)"##"#0&
###"$#66'4+'5
Ni-Cd/
Ni-MH
FRONT
Indicator
REAR
Indicator
Automatic Timer Shut-Off — turns off the
charger to prevent overcharging AA or AAA
batteries.
+/2146#06"5#('6;"
+05647%6+105
SAVE THESE
INSTRUCTIONS!
This manual contains important safety and
operation instructions for your battery
charger. Before using your charger, read all
instructions and cautionary markings on the
charger, the batteries to be charged, and the
product that uses the batteries.
."%#76+10".
Warnings:
Do not mix battery types (Ni-Cd and Ni-MH).
±"016'"±"
• Both batteries must be installed in the same
bay.
• It is normal for the batteries to become warm
while charging.
• Charge the batteries in an area with
temperatures between 32 and 113° F (0–45°
C). If the area is too cold, the batteries can
permanently lose their ability to charge. If the
area is too warm, the batteries will not fully
charge.
• Do not try to charge batteries other than
those listed in this manual, or use
procedures other than those described in
this manual.
• You cannot charge AA batteries in one bay
and AAA batteries in the other bay at the
same time.
• Charge only Ni-Cd or Ni-MH batteries
with this charger. Other types of
batteries might burst, causing personal
injury.
• Do not disassemble the charger; take it
to a qualified service technician when
service or repair is required. Improper
reassembly may result in a risk of
electric shock or fire.
• Do not use an attachment not
recommended or sold by RadioShack
as this could result in a risk of fire,
electric shock, or injury.
Tab
Charging
Bay
1. Slide Ni-Cd/Ni-MH to the desired setting.
2. Adjust the charging bay for AA or AAA
batteries.
The tab on the top of the front and rear
charging bays let you adjust the battery
holder for AA or AAA batteries. Pull
down the tab to charge AAA batteries.
Lift up the tab to charge AA batteries.
3. To charge two batteries, insert the
batteries in the front or rear bay
according to the polarity symbols
(+ and –) marked inside. .#±
To charge four batteries, insert the
batteries in the front and rear charging
bay according to the polarity symbols
(+ and –) marked inside.
4. Lift the AC plug’s prongs, located on the
rear of the charger, until they snap into
place. Plug the charger into a standard
AC outlet. FRONT lights when AA or
AAA batteries are charging in the front
bay. REAR lights when AA or AAA
batteries are charging in the rear bay.
Cautions:
• Do not expose the charger to rain or
excessive moisture.
AC Plug
• Do not operate the charger if it has
received a sharp blow, or been dropped
or damaged in any way. Take it to a
qualified service technician for repair.
Tab
• Do not use an extension cord. Its use
could result in fire or electric shock.
Charging
Bay
• Never use the charger as a DC power
source for any electrical equipment.
© 2002 RadioShack Corporation.
All Rights Reserved.
RadioShack and RadioShack.com are trademarks
used by RadioShack Corporation.
±"016'"±"
AA or AAA batteries will not be damaged if you
leave them in the charger until the timer turns it
off.
5. When charging is complete, the
indicator turns off. Unplug the charger
from the outlet, then remove the
batteries from the charger. ±
%*#4)+0)"#";8"$#66'4;
1. To charge a 9V Ni-Cd or Ni-MH battery,
snap the battery into the connectors in
the front charging bay as indicated by
the polarity symbols (+ and –) marked
inside.
2. Lift the AC plug’s prongs, located on the
rear of the charger, until they snap into
place. Plug the charger into a standard
AC outlet. FRONT lights.
3. The charger has no safety timer for
charging a 9V battery. See “Charging
Batteries with Different Capacities” for
the charging time. When charging is
complete, unplug the charger from the
outlet, then remove the battery from the
charger.
%*#4)+0)"$#66'4+'5"9+6*"&+(('4'06"%#2#%+6+'5
The charger can be used to recharge Ni-Cd batteries with capacities greater than 1000mAh
and Ni-MH batteries with capacities greater than 1800mAh. Simply reset the charger to begin
a second charge cycle for batteries with larger capacities. For batteries with less capacity,
simply remove batteries before the charge cycle is complete, based on estimated charge
times in the following table. ±
Limited Ninety-Day Warranty
$CVVGT["6[RG
This product is warranted by RadioShack against
manufacturing defects in material and workmanship
under normal use for ninety (90) days from the date
of purchase from RadioShack company-owned
stores and authorized RadioShack franchisees and
dealers. EXCEPT AS PROVIDED HEREIN, RadioShack MAKES NO EXPRESS WARRANTIES
AND ANY IMPLIED WARRANTIES, INCLUDING
THOSE OF MERCHANTABILITY AND FITNESS
FOR A PARTICULAR PURPOSE, ARE LIMITED IN
DURATION TO THE DURATION OF THE WRITTEN
LIMITED WARRANTIES CONTAINED HEREIN. EXCEPT AS PROVIDED HEREIN, RadioShack SHALL
HAVE NO LIABILITY OR RESPONSIBILITY TO
CUSTOMER OR ANY OTHER PERSON OR ENTITY WITH RESPECT TO ANY LIABILITY, LOSS
OR DAMAGE CAUSED DIRECTLY OR INDIRECTLY BY USE OR PERFORMANCE OF THE
PRODUCT OR ARISING OUT OF ANY BREACH
OF THIS WARRANTY, INCLUDING, BUT NOT LIMITED TO, ANY DAMAGES RESULTING FROM INCONVENIENCE,
LOSS
OF
TIME,
DATA,
PROPERTY, REVENUE, OR PROFIT OR ANY INDIRECT, SPECIAL, INCIDENTAL, OR CONSEQUENTIAL DAMAGES, EVEN IF RadioShack HAS BEEN
ADVISED OF THE POSSIBILITY OF SUCH DAMAGES.
Some states do not allow limitations on how long an
implied warranty lasts or the exclusion or limitation of
incidental or consequential damages, so the above
limitations or exclusions may not apply to you.
In the event of a product defect during the warranty
period, take the product and the RadioShack sales
receipt as proof of purchase date to any RadioShack
store. RadioShack will, at its option, unless otherwise
provided by law: (a) correct the defect by product repair without charge for parts and labor; (b) replace
the product with one of the same or similar design; or
(c) refund the purchase price. All replaced parts and
products, and products on which a refund is made,
become the property of RadioShack. New or reconditioned parts and products may be used in the performance of warranty service. Repaired or replaced
parts and products are warranted for the remainder
of the original warranty period. You will be charged
for repair or replacement of the product made after
the expiration of the warranty period.
This warranty does not cover: (a) damage or failure
caused by or attributable to acts of God, abuse, accident, misuse, improper or abnormal usage, failure to
follow instructions, improper installation or maintenance, alteration, lightning or other incidence of excess voltage or current; (b) any repairs other than
those provided by a RadioShack Authorized Service
Facility; (c) consumables such as fuses or batteries;
(d) cosmetic damage; (e) transportation, shipping or
insurance costs; or (f) costs of product removal, installation, set-up service adjustment or reinstallation.
This warranty gives you specific legal rights, and you
may also have other rights which vary from state to
state.
RadioShack Customer Relations, 200 Taylor Street,
6th Floor, Fort Worth, TX 76102
$CVVGT["%CRCEKV["*O#J+
'UVKOCVGF"%JCTIKPI"6KOG
AA
600
AA
850
4 hours, 35 minutes
6 hours, 30 minutes
AA
1000
7 hours, 40 minutes
AA
1500
11 hours, 25 minutes
AA
1600
12 hours, 10 minutes
AA
1800
13 hours, 40 minutes
AAA
180
3 hours
AAA
550
9 hours, 20 minutes
AAA
600
10 hours, 10 minutes
AAA
700
11 hours, 55 minutes
9V
120
7 hours, 20 minutes
9V
130
8 hours
To calculate the charge time for your battery, based on its rated capacity, use the following
formulas.
• For AA batteries: Charge time in hours = the capacity of your battery × 0.0076
• For AAA batteries: Charge time in hours = the capacity of your battery × 0.017
• For 9V batteries: Charge time in hours = the capacity of your battery × 0.0608
%#4'
5'48+%'"#0&"4'2#+4
Keep the charger dry; if it gets wet, wipe it
dry immediately. Use and store the charger
only in normal temperature environments.
Handle the charger carefully; do not drop it.
Keep the charger away from dust and dirt,
and wipe it with a damp cloth occasionally to
keep it looking new.
If your charger is not performing as it should,
take it to your local RadioShack store for
assistance. Modifying or tampering with the
charger’s internal components can cause a
malfunction and might invalidate its
warranty.
52'%+(+%#6+105
Input ................................................................................................................................... 120V AC, 60Hz
Output .............................................................................................. DC 2.8V, 170mA × 2 for AA Batteries
DC 2.8V, 80mA × 2 for AAA Batteries
DC 9V, 23mA for 9V Battery
Safety Timer .................................................................................................. 7.5 Hours for Ni-Cd Batteries
14 Hours for Ni-MH Batteries
Specifications are typical; individual units might vary. Specifications are subject to change and
improvement without notice.
12/99
RadioShack Corporation
Fort Worth, Texas 76102
23-437
0904-210-127401
06A02
Printed in China
Download PDF