Scion | xD 2011 | Installation guide | Scion xD 2011 Installation guide

Rev. 082614
BLUETOOTH INTERFACE FOR SELECT 1998-2011 TOYOTA & SCION VEHICLES
BEEBT-22
TOYOTA
2003 - 2011
2000 - 2009
2002 - 2011
1998 - 2011
2000 - 2005
2000 - 2005
2001 - 2011
1998 - 2011
2007 - 2011
2002 - 2010
2001 - 2005
2004 - 2011
2001 - 2005
2001 - 2011
1998 - 2011
1998 - 2011
2000 - 2011
2000 - 2011
2009 - 2011
2007 - 2011
SCION
2004 - 2011
2004 - 2011
2004 - 2011
2004 - 2010
4 Runner
Avalon
Camry
Corolla
Celica
Echo
Highlander
Land Cruiser
FJ Cruiser
Matrix
MR2
Prius
RAV4
Sequia
Sienna
Solara
Tacoma
Tundra
Venza
Yaris
We recommend reading this installation guide first before starting any
work. Following these instructions from “Start” to” Finish” will ensure
a smooth and hassle free installation. We offer telephone support M-F
9:00 AM – 5:00PM PDT toll free at 1 (855) 822-1348. We are here to
help.
PRELIMINARY:
- Disconnect the positive(+) battery cable for radios that are
non-navigation. Radios that are navigation ready should not
disconnect the battery cable. Please use caution when installing.
Do not install the interface near or on the vehicle’s HVAC system.
This will prevent overheating and condensation build up.
- Determine the proper installation method for your specific vehicle.
Use overview to help you determine installation method.
INSTALLATION
1. Remove the factory radio to gain access to the factory radio wiring
connectors.
2. Disconnect the factory connectors from the rear of the factory radio.
3. Connect the male connectors of the interface power harness into the
factory radio.
4. Reconnect the factory connectors into the mating connectors of the
interface.
5. Connect the male 3-pin connector the pigtail connector.
6. Route the microphone to a desired location, (for example above the
rear view miror).
7. Re-install a factory radio back into the vehicle’s dash.
TOYOTA STANDARD AUDIO
TO FACTORY
HARNESS
10-PIN
TO FACTORY
RADIO
10-PIN
(male plug)
(male plug)
6-PIN
xA
xB
tC
xD
PN: 1002507A
6-PIN
(male plug)
(male plug)
12-PIN
12-PIN
(male plug)
(male plug)
20-PIN
20-PIN
(male plug)
(male plug)
(male plug)
SCAN
MIC
AM
FM
TAPE
DISC
1
12-PIN
USING THE RADIO BUTTONS
VOICE DIAL
PRESS PWR BUTTON TWICE
ANSWER
PRESS PWR BUTTON ONCE
END A CALL
PRESS PWR BUTTON TWICE
REJECT
PRESS PWR BUTTON TWICE
ANSWER SECOND CALL
PRESS PWR BUTTON ONCE
SWITCH BETWEEN CALLS
PRESS PWR BUTTON ONCE
ENTER PRIVACY MODE
PRESS PWR BUTTON ONCE
INCREASE VOLUME
PRESS VOLUME UP ONCE
DECREASE VOLUME
PRESS VOLUME DN ONCE
ANSWER/END
12-PIN
12-PIN
TEXT
PN: 1002508B
(male plug)
20-PIN
TO FACTORY
RADIO
20-PIN
(male plug)
PWR
SKIP
2
3
4
RPT
5 RPT
RAND
SEEK
TRACK
6
1
2
3
AM
2
3
4
5
6
SCAN
TEXT
MUTE
SELECT
5
4
PTY
6
FM
DISC
FM
1/2
AM
SAT
DISC
SSP
AUX
iPod
ANSWER/END
SCAN
TUNE
PWR VOL
AUTO P
AUDIO
CONTROL
PUSHMODE
AM
FM
TAPE
DISC
1
DISC
SKIP
2
3
4
RPT
5 RPT
RAND
6
SEEK
TRACK
Note: If after a command the radio is powered “OFF”, you must power
“ON” the radio to regain volume control.
Note: If an incoming call is answered from the mobile phone’s keypad,
the call will direct itself to the headset on the mobile phone. To re-direct
the phone call to the “BEEBT-22”, it must be done directly from the
mobile phone.
Note: When transferring a phone call to the mobile phone for privacy,
the user must re-connect the
BEEBT-22 and the mobile phone by selecting the module from the
device menu on the phone.
Note: If after ending a call the radio is powered “OFF”, you must power
“ON” the radio to regain volume control.
All features of this module may vary by mobile phone
manufacturer. For questions on your mobile phone’s features,
please reference the mobile phone’s user manual for
information.
Note: On some older radios, the volume knob works in
reverse. (Eample: To lower the volume, turm the volume
knob clock-wise, and vise versa).
(male plug)
12-PIN
(male plug)
1
12-PIN
12-PIN
(male plug)
TA
AF
PN: 1002504
(male
plug)
12-PIN
(male plug)
TOYOTA PREMEIUM/JBL AUDIO
TO FACTORY
HARNESS
PUSH AUDIO CTRL
SEEK
TRACK
INTERNATIONAL HARNESSES NOT INCLUDED.
SPECIAL ORDER ONLY.
FOR CARS 1998-2003, WITH BASE
RADIO. VEHICLE MUST HAVE ONE OF
THE FOLLOWING FOR KIT TO
FUNCTION:
1. STEERING WHEEL CONTROLS
2. AVC CONNECTOR (XM PORT)
3. CD CHANGER PORT.
TUNE FILE
12-PIN
(female
plug)
12-PIN
(female plug)
AUTO P
VOL
PN: CJA25096
(male
plug)
12-PIN
(male plug)
INTERNATIONAL ADAPTOR
IMPORTANT NOTE
DISC
AUDIO CONT
PWR VOL
(female
plug)
12-PIN
(female plug)
PWR VOL
AUDIO
CONTROL
PUSHMODE
(male plug)
INTERNATIONAL ADAPTOR
ANSWER/END
TUNE
Note: The bluetooth module will re-connect with the last mobile phone’s
it was paired with. If no mobile phone is not found, it will
revert to the pairing process.
(male plug)
3-PIN
TOYOTA
AUTO RE-CONNECT:
1. The BEEBT-22 module will automatically re-connect the a previously
paired mobile phone when the ignition is turned “ON” to the vehicle
and the mobile phone’s Bluetooth feature is also on.
24-PIN
(male plug)
JBL
Note: The Bluetooth interface will remember upto the last 8 devices.
Note: If pairing is unsuccessful after several attempts power off then
power back on to re-attempt, if unsuccessful please contact our tech
support line.
OPERATING THE HANDS-FREE FEATURES ON THE RADIO
12-PIN
ANSWER/END
INITIAL PAIRING TO THE VOICE PROMPTS:
1. READY (POWER ON)
2. SEARCHING PHONES (FOR PREVIOUS PAIRED PHONES)
3. PLEASE SEARCH AND SELECT THE “BEEBT-22” DEVICE FROM
MOBILE PHONE AND ENTER “0000”.
4. YOU ARE NOW READY TO USE THE HF SYSTEM.
24-PIN
(male plug)
3-PIN
(male plug)
Note: The volume may vary at times. In order to correct the
volume level, you must set the volume knob to 0, then adjust
the volume level to your desired volume level.
Rev. 082614
BLUETOOTH INTERFACE FOR SELECT 1998-2011 TOYOTA & SCION VEHICLES
BEEBT-22
PRESS SEEK UP ONCE
END
PRESS SEEK DOWN ONCE
REJECT
PRESS SEEK DOWN ONCE
ANSWER SECOND CALL
PRESS SEEK UP ONCE
SWITCH BETWEEN CALLS
PRESS SEEK UP ONCE
ENTER PRIVACY MODE
PRESS SEEK UP ONCE
INCREASE VOLUME
PRESS VOLUME UP
DECREASE VOLUME
PRESS VOLUME DN
-
+
ANSWER
END
Does the audio on your radio
mute while using the mobile
applications on your mobile
phone?
Try placing your mobile phone
on vibrate, this will avoid the
radio mute interuption.
6-PIN
TO FACTORY
RADIO
Note: All menu structures work in 3 second increments.
If after 3 seconds the interface will time-out.
Use a T-Tap terminal to connect
the mute wire on the harness.
(See Fig.1) on page 2.
(male plug)
FOR CARS 1998-2003, WITH BASE
RADIO. VEHICLE MUST HAVE ONE OF
THE FOLLOWING FOR KIT TO
FUNCTION:
1. STEERING WHEEL CONTROLS
2. AVC CONNECTOR (XM PORT)
3. CD CHANGER PORT
Is there a pop sound being heard
when swtching sources on your
premium JBL radio system?
(male plug)
IMPORTANT NOTE
With the phone paired to the
UBT, enter the “SETTING
TTS
LEXUS
VOLUME” under
PWR VOL
menu structure.
The default level is
at volume 4.
20-PIN
Note: The menu structures only remember the last 24
numbers in the call log from dialed from the mobile
phone.
Have you paired your mobile
device, and get no sound from
the radio? Try reseting the TTS
volume setting.
6-PIN
1. Press the “PWR” button twice.
2. Press the “PWR” button once, to enter the menu options.
Continue pressing the “PWR” button twice till you hear the
interface announce “DO YOU WANT TO DELETE PAIRED
PHONE LIST”.
3. Press the “PWR” button once within 3 seconds to confirm.
4. The interface will ask “ARE YOU SURE”, press the “PWR”
button once to re-confirm..
Reset the radio using the
DVD-ROM originally included
with the vehicle.
(male plug)
END
Have you lost functionality on
your Navigation radio and/or
steering wheel controls?
10-PIN
DELETE ALL PAIRED DEVICES:
This feature allows you to delete all paired devices on the interface.
The module does NOT allow the user to only clear one device. The
module will delete all previously paired devices only
Remove the battery on the
mobile device for a minimum of
15 seconds.
(male plug)
SETTING TTS VOLUME:
1. Press the “PWR” button twice.
2. Press the “PWR” button once to enter the menu options.
Continue to press the “PWR” button twice till you hear the
interface announce “SETTING VOLUME”, and wait for her
announcement.
3. Set the TTS volume by turning the volume knob and waiting for
the announcement. Each announcement will indicate the volume
level of the TTS.
4. When the desired volume level is reached, press the “PWR” button
once to select.
Are you experiencing random
static interuptions durring your
phone calls?
24-PIN
ANSWER
OUTGOING CALLS:
1. Press the “PWR” button twice.
2. Press the “PWR” button once to enter the menu options.
Continue to press the “PWR” button twice till you hear the
interface announce “OUTGOING CALLS”, and wait for the numbers
to be announced.
3. When the number you wish to dial is announced, press the “PWR”
button once to make the call.
Delete all paired devices on your
mobile device and on the UBT.
(See Using The Menu Structure)
(male plug)
If your vehicle is equipped with these type of steering wheel controls,
they may be used to answer and end your phone calls as well.
INCOMING CALLS:
1. Press the “PWR” button twice.
2. Press the “PWR” button once to enter the menu options.
Continue to press the “PWR” button twice till you hear the
interface announce “INCOMING CALLS”, and wait for the numbers
to be announced.
3. When the number you wish to dial is announced, press the “PWR”
button once to make the call.
Have a bad connection when
using the A2DP or Handsfree
profiles?
TO FACTORY
HARNESS
MODE
MISSED CALLS:
1. Press the “PWR” button twice.
2. Press the “PWR” button once to enter the menu options.
Continue to press the “PWR” button twice till you hear the
interface announce “MISSED CALLS”, and wait for the numbers
to be announced.
3. When the number you wish to dial is announced, press the “PWR”
button once to make the call.
(male plug)
xA
xB
tC
xD
ANSWER
12-PIN
SCION
2004 - 2011
2004 - 2011
2004 - 2011
2004 - 2010
HOLD SEEK DOWN FOR 2 SECONDS
(male plug)
4 Runner
Avalon
Camry
Corolla
Celica
Echo
Highlander
Land Cruiser
FJ Cruiser
Matrix
MR2
Prius
RAV4
Sequia
Sienna
Solara
Tacoma
Tundra
Venza
Yaris
VOICE DIAL
3-PIN
TOYOTA
2003 - 2011
2000 - 2009
2002 - 2011
1998 - 2011
2000 - 2005
2000 - 2005
2001 - 2011
1998 - 2011
2007 - 2011
2002 - 2010
2001 - 2005
2004 - 2011
2001 - 2005
2001 - 2011
1998 - 2011
1998 - 2011
2000 - 2011
2000 - 2011
2009 - 2011
2007 - 2011
USING THE MENU STRUCTURE:
USING THE STEERING WHEEL CONTROLS
AM
SEEK TRA
Download PDF