REPLACING THE REMOTE CONTROL HT-135 06/01/08

REPLACING THE REMOTE CONTROL HT-135 06/01/08
06/01/08
REPLACING THE REMOTE CONTROL
HT-135
To ensure that Human Touch® products are repaired in a manner that is fully consistent with the practices used during the manufacturing process, Human Touch requires that all
product repairs are performed using only factory-new parts and in accordance with these product repair instructions.
SERVICE LEVEL: 1
Tools Required: Phillips-head screwdriver
NOTE: SAVE ALL REMOVED PARTS FOR USE DURING REASSEMBLY
REMOVING THE REMOTE CONTROL
Backrest release lever
1. Power off the chair and unplug it.
2. Push down on the backrest release lever, then fold the backrest forward
onto the chair seat (Fig.1).
3. Locate the remote control bracket on the back of the backrest (Fig.2).
4. Using a Phillips-head screwdriver, remove the four screws that secure
the remote control bracket to the backrest cover.
5. Pull the remote control cables through the backrest cover, then disconnect
the connectors.
NOTE: Be sure the backrest remote control connector does not fall back
into the backrest. If it does, remove the backrest by removing the four backrest
screws, using a 4 mm (5/32")
"") Allen key.
(Fig.1)
INSTALLING THE NEW REMOTE CONTROL
1. Connect the new remote control connector to the backrest remote control
connector, then push the cables into the backrest.
2. Using a Phillips-head screwdriver, replace the four remote control
bracket screws.
3. Power on the chair and verify that the new remote control works.
Please send any questions or comments regarding these instructions to: [email protected]
© 2008 Human Touch™, LLC.
(Fig.2)
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement