Dual | XD5125 | Troubleshooting guide | Dual XD5125 Troubleshooting guide

XD5125
INSTALLATION/OWNER'S MANUAL
AM/FM/CD Receiver
XD5125 INSTALLATION
Preparation
Please read entire manual before installation.
Before You Start
• Disconnect negative battery terminal. Consult a qualified technician for
instructions.
• Avoid installing the unit where it would be subject to high temperatures,
such as from direct sunlight, or where it would be subject to dust, dirt or
excessive vibration.
Getting Started
• Remove 2 transit screws located on top of the unit.
• Remove trim ring by pulling up gently in the center.
• Insert the supplied keys into the slots as shown, and slide the unit out of the
mounting sleeve.
• Install mounting sleeve into opening, bending tabs to secure.
• Connect wiring harness and antenna. Consult a qualified technician if you
are unsure.
• Certain vehicles may require an installation kit and/or wiring harness
adapter (sold separately).
• Test for correct operation and slide into mounting sleeve to secure.
• Snap trim ring into place.
2
XD5125 INSTALLATION
Installation
TYPICAL MOUNTING METHOD
3
XD5125 INSTALLATION
Wiring Diagram
FUSE
When replacing fuse,
make sure new fuse is the
correct type and amperage.
Using an incorrect fuse
could damage the radio.
The XD5125 uses one 0.5
amp AGC fuse (Ignition)
located in-line.
* Caution - Do not attach any speaker leads to ground as severe damage will occur.
4
XD5125 OPERATION
Control Locations
1
2
19
3
18
5
4
17
16
15
14
13
12
11
6
10
7
9
8
1 Release
10 EQ
2 Tuning
11 Display
3 Volume Up
12 Track Up
4 Mode
13 Track Down
5 Mute
14 Mono/Stereo/CD Intro
6 Audio
15 Local/Distance/CD Repeat
7 Eject
16 Loudness/CD Random
8 Auxiliary Input
17 Play/Pause
9 Band
18 Volume Down
19 Power
5
XD5125 OPERATION
General Operation
Faceplate Removal
Press RELEASE and pull away from the left side to
remove. To re-install, insert right side of faceplate first
then push left side to secure.
Power On/Off
Press POWER to turn the unit on. Inserting a CD will
turn the unit on automatically. Press POWER to turn the
unit off.
Mode
Press MODE to select between AM/FM, CD player or
auxiliary input. Modes of operation are indicated in the
display.
Note: CD only appears when a CD is inserted.
Loudness
Press LOUD to activate and deactivate bass boost
curve. Activating this feature will enhance the bass
frequencies when listening to music at all volumes.
Note: The instructions above apply to Tuner and
Auxiliary input modes. The activate/deactivate the
Loudness feature while in CD mode, press and hold
LOUD for more than 2 seconds.
Volume
Mute
Display
Auxiliary Input
6
Press VOLUME + or VOLUME - to adjust volume (0-63).
Press MUTE to silence the audio.
Press MUTE again to cancel.
Press DISP to display the clock for five seconds. The
radio frequency (tuner mode) or CD elapsed time/track
(CD player mode) show by default.
Insert 3.5 mm plug to connect your portable audio
device.
XD5125 OPERATION
General Operation
Set the Clock
Preset EQ Curves
Audio
Press and hold DISP until the clock begins to flash,
then release. Press TRACK to adjust the hours
and TRACK to adjust the minutes. Press DISP
momentarily to save the selected time.
Press EQ to select between POP, CLASSIC, ROCK
and OFF (default) equalization curves. The Bass and
Treble settings are not adjustable when an EQ curve
is selected.
Press AUDIO to select between Volume (default), Bass,
Treble, Balance & Fader.
VOLUME
BASS
TREBLE
BALANCE
Bass
Press AUDIO until BAS appears.
Press VOL - or + to adjust.
(-7 minimum / 7 maximum)
Treble
Press AUDIO until TRE appears.
Press VOL - or + to adjust.
(-7 minimum / 7 maximum)
Balance
Fader
FADER
Press AUDIO until BAL appears.
Press VOL - (LEFT) or + (RIGHT) to adjust.
(BA.L 10/BA.R 10) BAL 0 represents equal balance.
Press AUDIO until FAD appears.
Press VOL - (FRONT) or + (REAR) to adjust.
(FA.F 10/FA.R 10) FAD 0 represents equal fader.
7
XD5125 OPERATION
Tuner Operation
Tuning
FM Mono/Stereo
Local/Distance
Band
8
Turn the rotary encoder to tune the unit up or down
and select the desired station.
Press MONO during FM tuner operation to select mono
or stereo (default) reception of the broadcast signal.
Press LOC during FM tuner operation to activate local
tuning for strong station reception only. Press LOC
again to cancel and resume Distance tuning (default).
Press BAND to select between FM and AM bands.
XD5125 OPERATION
CD Player Operation
Insert CD
With the label facing up, insert a disc into the CD slot.
The CD will automatically begin playback.
Eject CD
Press the EJECT button to stop and eject CD. The unit
will change to tuner mode. If the disc is not removed
within 10 seconds, the unit will reload the disc.
Track Select
Fast Forward and Reverse
Pause
Intro
Repeat
Press TRACK to skip to the beginning of the next
track. Press TRACK to return to the beginning of
the current track. Pressing TRACK again skips to
the beginning of the previous track.
Press and hold TRACK
or TRACK
forward or reverse a track.
Press
Press
to fast
ll
/ II to temporarily stop CD playback.
/ II again to resume playback.
Press INT to play the first 10 seconds of each track.
Press INT to cancel.
Press RPT to continuously repeat selected track.
Press RPT to cancel.
Random
Press RDM to play all tracks in random order. Press
RDM again to cancel.
Loudness
Press LOUD for more than two seconds to activate/
deactivate the Loudness feature during CD play.
CD-R/CD-RW
Compatibility
Some CD-Rs and CD-RWs may be incompatible with
this unit, depending on media type and recording
method.
9
XD5125 WARRANTY
Limited One Year Warranty
This warranty gives you specific legal rights.
You may also have other rights which vary from
state to state.
Dual Electronics Corp. warrants this product to
the original purchaser to be free from defects in
material and workmanship for a period of one
year from the date of the original purchase.
Dual Electronics Corp. agrees, at our option,
during the warranty period, to repair any defect
in material or workmanship or to furnish an
equal new, renewed or comparable product
(whichever is deemed necessary) in exchange
without charges, subject to verification of the
defect or malfunction and proof of the date of
purchase. Subsequent replacement products
are warranted for the balance of the original
warranty period.
Who is covered? This warranty is extended to
the original retail purchaser for products
purchased and used in the U.S.A.
What is covered? This warranty covers all
defects in material and workmanship in this
product. The following are not covered:
installation/removal costs, damage resulting
from accident, misuse, abuse, neglect, product
modification, improper installation, incorrect
line voltage, unauthorized repair or failure to
follow instructions supplied with the product,
or damage occurring during return shipment
of the product.
10
What to do?
1. Before you call for service, check the
troubleshooting guide in your owner’s
manual. A slight adjustment of any custom
controls may save you a service call.
2. If you require service during the warranty
period, you must carefully pack the product
(preferably in the original package) and ship
it by prepaid transportation with a copy of the
original receipt from the retailer to an
authorized service center.
3. Please describe your problem in writing and
include your name, a return UPS shipping
address (P.O. Box not acceptable), and a
daytime phone number with your shipment.
4. For more information and for the location of
the nearest authorized service center please
contact us by one of the following methods:
• Call us toll-free at 1-866-382-5476
• E-mail us at cs@dualav.com
Exclusion of Certain Damages: This warranty
is exclusive and in lieu of any and all other
warranties, expressed or implied, including
without limitation the implied warranties of
merchantability and fitness for a particular
purpose and any obligation, liability, right,
claim or remedy in contract or tort, whether
or not arising from the company’s negligence,
actual or imputed. No person or representative
is authorized to assume for the company any
other liability in connection with the sale of
this product. In no event shall the company be
liable for indirect, incidental or consequential
damages.
XD5125 OPERATION
Specifications
CD Player
Frequency response: 20Hz-20kHz
Channel separation @ 1kHz: >50dB
D/A converter: 1 Bit
FM Tuner
Tuning range: 87.5MHz-107.9MHz
Usable sensitivity: 15dBf
50dB quieting sensitivity: 23dBf
Stereo separation @ 1kHz: 25dB
Frequency response: 80Hz-10kHz
AM Tuner
Tuning range: 530kHz-1720kHz
AM sensitivity: 30uV
Frequency response: 80Hz-1.8kHz
General
Operating voltage: 11-16 VDC, negative ground
Speaker output impedance: 4~8 ohms
Fuses: 0.5 amp fast blow AGC, 5 amp fast blow AGC
Dimensions: 7" x 7" x 2" (178 x 178 x 51 mm)
Design and specifications subject to change without notice.
CEA-2006 Power Standard Specifications
(reference: 14.4VDC +/- 0.2V, 20Hz~20kHz)
Power Output: 5 Watts RMS x 4 channels at 4 ohms and < 1% THD+N
Signal to Noise Ratio: 80dBA (reference: 1 watt into 4 ohms)
11
XD5125 OPERATION
Troubleshooting
Problem
Unit will not
turn on
(no power)
Cause
Action
Yellow or red wire not connected or
incorrect voltage
Check connections for proper
voltage (11~16VDC)
Black wire not connected
Check connection to ground
Fuse blown
Replace fuse
Unit has power Speaker wires not connected
Check connections at speakers
(but no sound) One or more speaker wires touching Insulate all bare speaker wires
each other or touching chassis
from each other and chassis
ground
ground
Unit blows
fuses
Excessive
skipping
Yellow or red wire touching chassis
ground
Check for pinched wire
Speaker wires touching chassis
ground
Incorrect fuse rating
Check for pinched wire
Unit is not mounted correctly or
backstrap is not secure
Check mounting sleeve and
backstrap support
Physical defect in media
(CD, CD-R or CD-RW)
Check media for scratches
Err appears on Load/Eject operation error or disc is
display
in upside down
Use fuse with correct rating
Press eject
Dual Electronics Corp.
Toll Free: 1-866-382-5476
www.dualav.com
©2008 Dual Electronics Corp. All rights reserved.
NSA0508-V02
Download PDF