5. Remote & RCA 6. Ground Cable 7. Diagram
Make sure the car stereo is turned off for this step.
1. Route the remote wire and RCA cables through the inside of the vehicle from the car stereo to the amplifier’s location.
(Run the RCA cables from the opposite side of the routed remote and power cables)
2. Identify the Left and Right channel and connect the RCA cable to the car stereo.
3. Attach the remote wire to the remote wire on the stereo.
4. Connect the other end of the remote wire and RCA cable to the amplifier.
Make sure the negative terminal from the battery is disconnected.
1. Trim half an inch of insulation from the ground cable and attach to the included ring connector.
2. Install the ring connector to the vehicles metal body, 5 feet from the amplifier. (Surface must be clean and bare metal)
3. Connect the ground cable to the amplifier’s negative (-) terminal.
4. Conect the negative cable back onto the battery.
| 6 | 7
Battery
Fuse
Power Cable
Speaker Wire
Amplifier
Remote Wire
RCA Cable
Car Stereo
POWER WIRING KITS
SPECIFICATIONS
Power Cable
Ground Cable
Remote Wire
Speaker Wire
RCA Cable
Fuse Holder
Fuse
4 Gauge x 16ft (4.88M)
4 Gauge x 3ft (0.9M)
18 Gauge x 15ft (4.6M)
12 Gauge x 20ft (6.1M)
15ft (Unbalanced, Stereo)
4 Gauge (AGU type)
60A AGU
VM Audio Tech Support
US / Canada phone: (855) audio-99 / (855) 283-4699 email: [email protected]
| 8
© VM Audio All rights reserved. All trade names are registered trademarks of respective manufacturers listed.
POWER WIRING KITS
SRPK4R / SRPK4B
Quick Installation
Guide
Rev. 1
1. Introduction
Thank you for your interest in VM Audio products. Our goal is to enhance your listening experience.
The Shaker series is designed with the casual users in mind as the economical solution to a performance craving consumer. The experts and engineers at
VM Audio meticulously tested and designed this product with a reasonable price tag to fit any budget. Let the
Shaker series maximize the value of your investment.
Cables & Wires
2. Contents
GROUND CABLE REMOTE WIRE
POWER CABLE
| 1
SPEAKER WIRE RCA CABLE
| 2
Contents (continued)
Accessories
TIE WRAPS
RUBBER RING
FUSE
(3) SCREWS
3. Fuse Installation
Car Battery
18” (457mm)
4. Power Cable
(2) SPADE
CONNECTORS
CABLE LOOM
(SRPK4R only) (2) RING
CONNECTORS
Make sure the negative terminal from the battery is disconnected.
1. Mount the fuse holder securely approximately 18 inches or less from the battery.
2. Trim the insulation of the power cable by half an inch and connect it to the fuse holder screwing down tightly.
Note: Complete this step before installing the fuse.
Make sure the negative terminal from the battery is disconnected for this step.
1. Route the power cable through the vehicle’s firewall from the fuse holder to the amplifier.
2. Trim the insulation of the power cable by half an inch from both ends and connect one end of the cable to the fuse holder and the other to the positive terminal of the amplifier.
(3) BUTT
CONNECTORS
(4) FASTON
CONNECTORS
(5) SPADE
CONNECTORS
| 3 | 4 | 5