PISO CAN200U

Universal PCI CAN Communication Card
PISO-CAN200U-D
PISO-CAN200U-T
The PISO-CAN200U can represent an economic solution of an active CAN board with universal PCI
bus. It has 2 independent CAN bus communication ports with 5-pin screw terminal connector or 9-pin
male D-sub connector, and has the ability to cover a wide range of CAN applications. Besides,
PISO-CAN200U uses the new CAN controller Phillips SJA1000T and transceiver 82C250, which
provide bus arbitration, error detection with auto correction and re-transmission function. It can be
installed in both 3.3 V and 5 V PCI slot and supported truly “Plug & play”.
Hardware architecture
Compatible with CAN 2.0 parts A and B
Fully compatible with ISO 11898-2 standard
Support CAN bard from 10 kbps ~ 1 Mbps
2500 Vrms photo couple isolation on the CAN bus
Universal PCI supports both 5 V and 3.3 V PCI bus
Built-in jumper to select 120 Ω terminal resister
3 kV galvanic isolation
2 independent CAN channels
Direct memory mapping to the CAN controller
Provide VB6.0, VC++6.0, Delphi, BCB6.0 demos
LabView/DASYLab driver
Driver support Windows 98/ME/NT/2K/XP/7
Pin Assignments
Software Layer
Terminal Resistor
1-41
Model Name
Bus Interface
Type
PISO-CAN200U-D
PISO-CAN200U-T
Universal PCI, 3.3 V and 5 V, 33 MHz, 32-bit, plug and play
CAN Interface
Controller
Transceiver
Channel number
Connector
Baud Rate (bps)
Terminator Resistor
NXP SJA1000T with 16 MHz clock
NXP 82C250
2
9-pin male D-Sub
5-pin screwed terminal block
10 k, 20 k, 50 k, 125 k, 250 k, 500 k, 800 k, 1 M (allow user-defined baud rate)
Jumper for 120 Ω terminator resistor
Power
Power Consumption
250 mA @ 5 V
Software
Driver
Library
Windows 98/ME/NT/2K/XP/7, Linux 2.6.37, LabView, DASYLab
VB 6.0, VC++ 6.0, BCB 6.0, Delphi 4.0
Mechanism
Dimensions
126mm x 22mm x 85mm (W x L x H)
Environment
Operating Temp.
Storage Temp.
Humidity
0 ~ 60 ℃
-20 ~ 70 ℃
5 ~ 85% RH, non-condensing
Utility
Can be a CAN system monitor tool with CAN cards
Can test CAN cards
Send/Receive/Record CAN messages
Provide cyclic transmission function
Record the CAN messages with filter ID with time stamp
Flow Diagram for Applications
Ordering Information
PISO-CAN200U-D CR
PISO-CAN200U-T CR
2-Port Isolated Protection CAN Communication Board with 9-pin D-sub connector
(RoHS)
2-Port Isolated Protection CAN Communication Board with 5-pin Screw Terminal
Connector (RoHS)
1-42

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project