Output Module Installation

Output Module Installation
EN S E MB L E
D
E
S
I
G
N
DS-1 Output Installation
S
November 21, 1997
DS-1 Output Module Installation
Note: Normal electro-static discharge protection techniques should
be observed throughout this procedure.
1. Turn off power switch and disconnect the power cable from the
rear of the unit. Place the DS-1 on the bench top with the front panel
toward you.
2. Remove the top cover of the DS-1 by removing the14 screws from
the top of the unit. Note: There are two nylon standoffs which
support the lid. These standoffs may remain attached to the two
screws in the center of the lid.
3. Slide the Output Module BNC connectors through the
corresponding holes of the DS-1 chassis. Attach the ribbon cable to
the J13 (Output 3) or J14 (Output 4) connector of the DS-1
motherboard and press down firmly.
4. Place a lockwasher and nut over each of the two BNC connectors
and tighten the nuts.
5. Reverse the above procedure to reassemble. If the nylon
standoffs remained on the lid when it was removed, gently remove
them from their screws and install them in the DS-1 module.
6. For safety, put the lid in place and attach with two screws.
Connect the power cable. When the Menu button is pressed it should
illuminate, and menu functions will be operative. Disconnect power
cable.
7. Re-install the remaining lid screws. Note: When tightening the
screws into the nylon standoffs, do not overtighten. Connect power
cable and turn unit on.
PO Box 993
•
Grass Valley,
CA
95945
•
(530) 478-1830
•
FAX (530) 478-1832
•
[email protected]
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement